Camar068's latest activity
-
Camar068 reacted to Tonimus's post in the thread Engine & transmission removal & reinstall general tips with
Like.
I would advise pulling the radiator just to be safe. It's only two more lines if you're running the trans cooler. The carb plate is... -
Camar068 replied to the thread 04 LM7 into 87 K5.Also, I deleted the trans range sensor. One less thing to fail later and was a simple programming for 1 signal wire on pin 34 for...
-
Camar068 replied to the thread Mastercraft 31's or 32'.Still got this to measure from fender to ground at center of hub? Hoping I'll get lucky with the new monroe coil overs and have...
-
Camar068 replied to the thread Gear Ratio.Sorry for being vague, why is the price so high? I had mine changed (front/rear) for about $1,200 and that included new front wheel...
-
Part 2 The shop had to cut new slots in the foam for the correct listings, and fill the old ones. The factory lines are left to right...
-
I know that this has been a topic of many discussions on these boards. A lot of us love the look of bucket seats and a console in our...
-
Camar068 replied to the thread 04 LM7 into 87 K5.Found the post: LS 4WD Per LT1, Green pin 16 is used if using the VSS from the transfer case. Otherwise, remove. That's what I did...
-
If you have the speed sensor before the transfer case there will have to be some way to tell the speedo it’s in low vs high range to...
-
Camar068 replied to the thread 04 LM7 into 87 K5.I think if you put the reluctor on the transmission output shaft, you don't have to have the "4LO" signal to the ecm. I don't use 4LO...
-
Camar068 replied to the thread 04 LM7 into 87 K5.yes you can use a pass-through adapter that will give the signal and still use the cable driven speedo. I put a reluctor wheel on the...
-
Camar068 replied to the thread Gear Ratio.wow.....why so high?
-
Camar068 replied to the thread What radiator are you using for the 5.3.Using stock 86 k10 rad with a fitting soldered in for the steam vent line a few inches below the cap. Windstar, TYC 620270, fan for...
-
Camar068 replied to the thread What new tools have you got lately?.Just like my hunting/skinning knives....you'll never lose it :)
-
I’ve had a large set that my dad got for me from Craftsman about 25 years ago. Maybe less, maybe more, but they’ve always been helpful...
-
Camar068 replied to the thread What new tools have you got lately?.Never knew self adjusting channel locks existed. Gonna get a set. Any Cons to them? Husky Self Adjusting Channel Locks
-
