BadBowtie's latest activity
-
A/C trucks were vacuum controlled by Heat/A/C controls, non A/C trucks got a pull handle. No drivers side vent. LMCs site under... -
Plugged it in and now works perfectly
-
there was a connector coming out of the seat belt buckle, and i plugged it in and it worked like it should. im assuming the switch...
-
Located here-see attachment I've only personally fixed 85 and older- but should be the same.
-
Hi all, I am trying to work out all of the kinks of my 87, I am trying to get my truck to do it's seat belt warning chime when the key...
-
https://www.summitracing.com/parts/gte-44891 I used this flasher but had to use jumpers to flip flop where they plugged in. Sylvania leds
-
That's what I did on mine. Everything works fine.
-
LEDs have a much lower resistance than incandescent light bulbs. By wiring in the extra resistors you are basically putting the...
-
The flasher relay is not enough, I had to wire in 50ohm resistors at each tail light and each front marker light. That fixed all my...
-
My thought is still the relays. LED (electronic) relays terminals can be backwards to what is needed-causing them not to work. Link to...
-
I bet this has been discussed, but I have looked and looked and can't find the answer. I just finished restoring my dad's 82 GMC and...
-
Thanks guys, good to know. Tomorrow will be somewhat sunny so I’ll see if I can see how far off it is. I don’t mind if it’s a little...
-
As stated, '81-up is slightly thinner (like, 1-2mm, BARELY thinner). Not sure about the tint, all our repop stuff has the same shade to...
-
I've had SB from 74-85 and lots of them. The vent structures do interchange. The tints really didn't change from newer to older as I...
-
Cool, thanks. In your experience, is the blue hue of the earlier glass darker than the later stuff?
