AZ Highlander's latest activity
-
Turn any nut and bolt into a Nylock. Cut a small piece of fishing line. Put it through the nut, tighten down the bolt. Works great on... -
It will be an ACDelco R45TS. That was the specified plug for almost every small block(and some big block) GM engine for decades. My 71...
-
ACDELCO. Gap is .045 with HEI if I recall correctly, and .035 with points. Go to the local auto parts store, rock auto, or whatever...
-
AZ Highlander reacted to ChuckN's post in the thread What have you done to your square lately?? with
Like.
Drove the truck to my knee appointment after going one step leaner with the metering rods- big mistake! Way too lean. But interesting to... -
AZ Highlander reacted to Chevrolado's post in the thread What have you done to your square lately?? with Like.
Why is it the simple little things that are so entertaining to me... :D Got the rubber stopper (only one tab left on my tray) and new...
-
AZ Highlander reacted to SirRobyn0's post in the thread Sliding Window Restoration Tips Please? with Like.
Well it worked for me anyway and my slider is still going strong. The rubber / silicone thing you mentioned, You could probably get...
-
AZ Highlander reacted to JamesSam's post in the thread Sliding Window Restoration Tips Please? with Like.
I air sprayed the dust out of the channel, cleaned with alcohol wipes and q-tips, then sprayed some double u dee 40 silicone spray to...
-
AZ Highlander replied to the thread Sliding Window Restoration Tips Please?.Sam, did you ever rehab your rear sliding window? The directions @SirRobyn0 gave are what I plan to follow for mine, but it also appears...
-
AZ Highlander reacted to brooksman9's post in the thread Sliding Window Restoration Tips Please? with Like.
What about the weather strip seals, ask about those JamesSam. You know, just in case anyone else is curious. :)
-
AZ Highlander reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
Also got more 5/8" hardware to upgrade the 1/2" on the truck, old vs New brackets, another hitch receiver I'm going to add below the...
-
AZ Highlander reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
Some progress Remade the front brackets going to use some 1/4" scrap to make some gussets still need to drill some holes but my old...
Latest posts
-
-
Will a 8.5 Camaro 10 bolt axle fit in a 1981 squarebody?- Latest: Ryanbrown36
-
-