AuroraGirl's latest activity
-
AuroraGirl reacted to HotRodPC's post in the thread Turbo350 w/shift kit slamming 2nd gear with
Like.
Jep, I know all this to be true up until the swap of granny to OD. Mr Lee Iococa is the one who saved Chrysler/Dodge and all he really... -
Yep, the lower the pressure (or vaccum) the lower the boiling point.
-
AuroraGirl replied to the thread 700r4 & Edelbrock TV Bracket.also late th350 uses a tv cable thats actually a kickdown cable. ANNOYING.
-
The return setup would be preferred with today’s lousy gas. The 3 port pumps have a tiny orifice in the return fitting, basically a...
-
AuroraGirl replied to the thread Smoking Ground Wire.the poor decision to use the thermostat housing to ground the PCM and run the engine ground was a poor choice
-
Start with the dash cluster. There should be a black ground wire up high under the dash. On an '87 I think there is a ground bus it...
-
AuroraGirl replied to the thread Faulty rigged.The weird part to me is the manual valve, you both seem to have had a solenoid
-
My truck had a dealer-installed aux tank and it looked just like the square one in your picture. I got a factory tank, solenoid, hard...
-
-
AuroraGirl replied to the thread Smoking Ground Wire.you need to shore up the grounds. Heads to the firewall. frame to core support. Engine to battery. core support to battery.
-
AuroraGirl replied to the thread Mechanical fuel pump return line.Heres my 3 port pump, for another example
-
-
AuroraGirl replied to the thread Mechanical fuel pump return line.not sure about 85 but there is a chance HD emissions without evap may have been offered in 85, if it was, there would be short little...
-
I didn't suss it out line by line but I think we are saying the same thing. The only item I would take issue with is the picture of the...
-
AuroraGirl replied to the thread Mechanical fuel pump return line.also even if the fuel wasnt vapor in the line, the moment it starts sucking gas , you will cause it to boil (under a vacuum, the boiling...
-
As AuroraGirl said, make sure the sending units are grounded. Unscrew the bolt, sand down the frame to bright metal, and screw back in...
