Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
Registered members
Current visitors
Menu
Log in
Register
Install the app
Install
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
AuroraGirl's latest activity
AuroraGirl
replied to the thread
Front end noise
.
Can you temporarily remove the ends of your hubs so you free wheel to see if the NP203 differential is doing its job
Oct 26, 2024
AuroraGirl
replied to the thread
Front end noise
.
You have NP203 with always locked hubs?
Oct 26, 2024
AuroraGirl
reacted to
Radiohead's post
in the thread
Front end noise
with
Like
.
Bearings done recently brings something to mind. Have you re-checked the bearing preload?
Oct 26, 2024
AuroraGirl
replied to the thread
after doin front end clutch and steering column,truck feels like its in 4wd
.
i think he meant the hop would be pronounced more, because of the torque increase did the OP say anything about if he unlocked his...
Oct 26, 2024
AuroraGirl
replied to the thread
Front end noise
.
Hoses that are twisted (think rotating the caliper when its removed) or stretched will apply the brake because it squeezes the fluid...
Oct 26, 2024
AuroraGirl
reacted to
Chris64's post
in the thread
Front end noise
with
Like
.
Well, the e-brake cable is just the rear-end probably (I re-read the title). But also the actual brake rubber hoses may need to be...
Oct 26, 2024
AuroraGirl
replied to the thread
HEI module dwell time.
.
too hot of spark, maybe it was from the plug being hot enough to cause it to fire without a spark, wonder how a modern iridium with a...
Oct 26, 2024
AuroraGirl
reacted to
Matt69olds's post
in the thread
HEI module dwell time.
with
Like
.
Oldsmobile use to specify .080 plug gap, and then later revised it. If I remember correctly, the issue was low speed misfired and...
Oct 26, 2024
AuroraGirl
replied to the thread
Blower motor wont turn off
.
I had to replace a limit switch on 2 riveter machines at work. My smaller hands and mechanical knowledge apparently made me the person...
Oct 26, 2024
AuroraGirl
replied to the thread
HEI module dwell time.
.
hm they must not have decided to stick with larger gap then, probably was causing engine chuggle or harshness in lockup at certain speeds
Oct 23, 2024
AuroraGirl
reacted to
Gliderider's post
in the thread
Potential wiring problem
with
Like
.
I followed the wire all the way to the back of the motor where it goes into a sleeve, the sleeve comes back across the firewall behind...
Oct 22, 2024
AuroraGirl
replied to the thread
Blower motor wont turn off
.
Prob have a bad relay or something 1982 the feature to turn off the fan came out.
Oct 22, 2024
AuroraGirl
reacted to
EvilGenius's post
in the thread
Blower motor wont turn off
with
Like
.
It runs constantly in my 83 k10 with an 85 interior harness. The off position is slower than Low, but it still runs. I only drive my...
Oct 22, 2024
AuroraGirl
replied to the thread
Potential wiring problem
.
I accidently snagged the coolant sensor wire on my 1980 between the head and the valve cover , if you possibly did something similar...
Oct 22, 2024
AuroraGirl
replied to the thread
Potential wiring problem
.
have you had the cluster out lately?
Oct 22, 2024
Latest posts
M
How far do long tube headers hang down
Latest: m1028cucv
Today at 6:25 PM
Tech Discussion
LMC Dash Pad Supplier
Latest: WFarm
Today at 6:17 PM
Interior
Is this fender original or aftermarket?
Latest: legopnuematic
Today at 6:05 PM
Paint and Body
GMC-IH
Latest: dragstews
Today at 3:39 PM
Other Vehicles
Forum statistics
Threads
44,157
Posts
950,599
Members
36,273
Latest member
dannyphx
Members
Top