75gmck25's latest activity
-
75gmck25 replied to the thread LMC Dash Pad Supplier.If you want a different color than black for the AMD pad, can you dye it another color, or does that not work with black? My original... -
75gmck25 replied to the thread New stater not catching.Did you measure the clearance between starter gear and the flywheel, and use shims to adjust it?
-
75gmck25 replied to the thread How far do long tube headers hang down.I went with the Sanderson headers because they fit better with my Blueprint heads. However, they are shorty headers that only come...
-
75gmck25 replied to the thread No dash lights suddenly, just the small gauges, on the 77..There aren’t really that many bulbs in the cluster. Maybe 5 white dash lights, and the rest are turn signals and high beam indicator...
-
75gmck25 replied to the thread Engine Block Heater for SBC 350.One risk with a dipstick heater (but also maybe an old wives tale) is that you have a heated electrical probe running down into the oil...
-
75gmck25 replied to the thread Big block running hot. Can’t figure out the issue.I had radiator issues, and replaced it with a Champion all aluminum radiator from Jegs. I have a stock v-belt system and an HD fan...
-
75gmck25 replied to the thread Engine Block Heater for SBC 350.I grew up in ND, and freeze plug (or block) heaters were installed on just about every carbureted vehicle. You can put it on a timer...
-
75gmck25 replied to the thread Rear disc conversion.14 bolt FF should be a direct bolt on to the springs, but the driveshaft connection might be different. Many of them are also 4.10 or...
-
75gmck25 replied to the thread CARBURETOR DATED.I have a Quadrajet with a four hole spacer and it’s tuned the best I could do myself. If it’s only been sitting a couple of days I just...
-
75gmck25 replied to the thread Tire size confusion..After GM switched from 16.5” to 16” tires, the standard size for HD trucks was usually 235/85R16E or 245/75R16E. Your glove box sticker...
-
75gmck25 replied to the thread What headers will fit a Blueprint 454 in a 1987 K10/V10.I have Blueprint heads on my SBC and it was a PIA to fit spark plug wires with stock iron exhaust manifolds because of the difference in...
-
75gmck25 replied to the thread Carb gasket comparison question!.Check to see what passages those holes line up with in the carburetor. If the carburetor plate is solid in those areas, then the gasket...
-
75gmck25 replied to the thread 87 receivers.Some of the older hitches were designed in three pieces so they would fit multiple brands of trucks. There was a standard crossbar and...
-
My '75 K25 has a 350 with aluminum heads, 213/[email protected] retrofit roller cam, Edelbrock Performer intake, and a Quadrajet that has been...
-
75gmck25 replied to the thread Non EEC fuel tank vent.My ‘75 has three port sending units, and both sides go to a T fitting. That fitting connects to a metal line that runs up to the engine...
