75gmck25's latest activity
-
75gmck25 replied to the thread 73 C10 Rear End Small Lift Needed.Shackles are easy, but not good for stability and load carrying unless they are really stiff. Blocks are probably a better choice, but... -
75gmck25 replied to the thread Coolant Hose Popped Off the Thermostat.First thing I’d do is to replace the radiator cap. If the pressure release is bad it might let it get too high. I think the stock cap...
-
75gmck25 replied to the thread RETRO-Mod: Jeep intermediate steering shaft.I bought the Borgeson steering shaft and thought I had a similar problem. Turned out to be a non-issue, so maybe the solution will work...
-
75gmck25 replied to the thread Help With Parking Break Dash Light Staying On.Check the small switch on the parking brake pedal mechanism. It may be broken, or not screwed on tight. Proportioning valve can also...
-
75gmck25 replied to the thread 78 K-10 Dual Tank Install.Saw your posts, but I’m not sure if you have a question about the dual tanks or are trying to post an answer. AFAIK, the old 6 port...
-
75gmck25 replied to the thread Can I use this hole for filling oil?.PCV always need an "in" port in one valve cover and an "out" port in the other valve cover. The PCV pulls constant vacuum toward the...
-
75gmck25 replied to the thread Bare Hands.I try to use nitrile gloves as much as I can for drivetrain work, but have to use the large HD gloves from Harbor Freight so that they...
-
75gmck25 replied to the thread Two piece front drive shaft.Based on parts from RockAuto, you need a 23 7/8” drive shaft, and your old one is probably 29 1/2”, measured from center of one u-joint...
-
75gmck25 replied to the thread Can I use this hole for filling oil?.You just need to put a rubber grommet insert in each of the holes. It might take a little experimenting, because there is one size...
-
75gmck25 replied to the thread Newbie needs help, replace starter now some gauges don’t work.Large starter lug should have the main battery cable and at least two smaller cables on it. The two smaller cables are the feed to the...
-
75gmck25 replied to the thread Intermittent steering wander?.Have you checked to see that you get an equal number of turns of the steering wheel turning full lock left to right? If the steering...
-
75gmck25 replied to the thread Distributor will hit edelbrock 3764 intake.Also, when you "move" the #1 cylinder on the cap, the firing order is still the same, so all the other wires on the cap have to move the...
-
75gmck25 replied to the thread Front end noise.My truck with NP203 started making loud clicking noises (not a clunk), and it turned out to be the u-joints (rusted, roller bearings had...
-
75gmck25 replied to the thread CARBURETOR DATED.Some of the basic Edelbrock intakes, like the Performer, are drilled for both spreadbore and squarebore patterns, so you can swap...
-
75gmck25 replied to the thread CARBURETOR DATED.Sounds like it needs a minor adjustment, not a full rebuild. With a warm engine you can easily get too much fuel for a reliable hot...
