6
68post
Latest activity Postings About
-
-
6You have to measure the stack like I said earlier, if you run that .038 head gasket and your piston is .025 down in the block thats a...
-
668post reacted to Nardulli's post in the thread Small Block choices: A feller has too many with
Like.
Update: of the 3 blocks I had, two were cracked. That made the selection simple. Ended up .030 over, 400 crank, 6" rods, 64CC new... -
6This was a bittersweet day, but I have sold my K10. I hope to come back to this community one day again in the future to build another...
-
6I apologize as I am one of the guilty ones that said I'd message you and didn't. I appreciate your willingness to cut some frame and I...
-
6Not much rust in my neck of the woods(eastern oregon) Just about every farmer around here has a square body sitting on a ditch bank...
-
668post reacted to Matt Lutz's post in the thread intergrated heads, options and modification with Like.
If you are close to Texas I just took a 250/6 out of my GMC. Make you a great deal! Standard head and exhaust manifold on it. I also...
-
668post reacted to Ricko1966's post in the thread Small Block choices: A feller has too many with Like.
It's been a while but I think the 040 heads were the hot ticket at one point in time. Decent flow 64cc,late bracket holes. All from...
-
668post reacted to 75gmck25's post in the thread Small Block choices: A feller has too many with Like.
I used Mahle .026 head gaskets with my crate 350 and 64cc Blueprint heads, to try and make up for the low compression of the stock...
-
6!! THM 400 on steroids !! ... Like a rock ... Or a tank ..
-
6Starting a 4L80E information thread for those that want to learn more about this transmission (the best GM ever produced in my humble...
-
6Well, it’s taken a minute…but the engine checked out, we did have to take it to .040 over. Blew up my budget as it came out to a little...
-
6A well done 400 gets on most BBCs, and smokes a 383, before there was an aftermarket I was running 9s NA with production 400 blocks and...
-
6Is this motor torn down already? If the crosshatch is still there and no ridge, I'd clean it, run a dingleberry hone, new bearings...
-
6No. Heads are where you are going to make all your power. Stock smogger truck heads will never flow enough to make that kind of power...
-
6If he does the 350 crank 400 block just use the 400 pistons with 350 rods. But this engines already been rebuilt and runs! So my opinion...
-
-
Loading…
-
Loading…
Latest posts
-
Anyone else have this "Turbo Diesel" plaque?- Latest: TheBigBlue2500
-
-
-
