B
BryanS
Latest activity Postings About
-
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.Next question. Not sure if this should be a different thread but it seems all the right people are looking at this one :) My front axle...
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.Got it. That makes perfect sense
-
BThe “261” on the bottom of that tag denotes the low range gear ratio - 2.61:1.
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.I may have seen the wrong numbers Is this the tag I should be looking at? The front shaft is on the correct (passenger) side Here...
-
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.I think it’s NV261
-
BI’m swapping a 14bolt FF into a k5 Truck has a 4”lift and currently the slip yoke sits out pretty far. Drive shaft looks like it is 2-3...
-
-
BBryanS replied to the thread Replacing rear axle on 83 k5.OK About to pull the trigger on a 14 bolt FF with 4.10 and factory locker. Also a driveshaft from the suburban I need to have cut...
-
BBryanS replied to the thread AN fittings need to be drilled?.Thanks puffy I’ll look at them.
-
BBryanS replied to the thread Reverse light options.Move to a better state? FL has no inspections…at all
-
BBryanS replied to the thread Hilly carb on edelbrock performer BBC.Got it Thanks! PO set up with “regular” open square gasket. Blocking some of the opening. The truck idled crappy. Think this may have...
-
BThe performer manifolds are designed for use with a spread bore or a square bore carb. When using a square bore carb, there's a flat...
-
BHi team I have a 454 with a performer intake I’m changing the carb from a 600 holly to a 750 vac secondary The new (and old in...
-
-
BBryanS replied to the thread AN fittings need to be drilled?.I have stuff from them. I like them. Actually looking at an oil cooler too. The reason I got the ones I did was I wanted RED ones and...
-
BFor future reference, the Evil Energy stuff on Amazon is actually pretty nice quality stuff. I was very surprised.
-
BBryanS replied to the thread AN fittings need to be drilled?.I’ll do that. my only real problem is going to be figuring out how to sleep at night knowing the inside of the fitting will be all...
-
-
Loading…
-
Loading…
