BryanS's latest activity
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.I would be happy with 300-400 44 in 4:10 I need to find one first :)
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.I really not interested in 1200 junk yard 44. I called a few of the local yards and no one had what I was looking for. 8 bolt 73-87 I...
-
BFor that kind of money I'd just hold out for a Dana 60. you can still find them sometimes for $1000 and if it's local to you, then no...
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.So where I’m at now is just finding a d44 from 3/4 ton 8 lug and swapping the whole thing. I would do a 60 if I can afford it I see...
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.Or drill new holes in the one I have?
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.Or can it be a Dana 44?
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.So I have to find a 2500 8 lug 10 bolt to raid for parts? Specifically the backing plate?
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.Next question. Not sure if this should be a different thread but it seems all the right people are looking at this one :) My front axle...
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.Got it. That makes perfect sense
-
BThe “261” on the bottom of that tag denotes the low range gear ratio - 2.61:1.
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.I may have seen the wrong numbers Is this the tag I should be looking at? The front shaft is on the correct (passenger) side Here...
-
-
BBryanS replied to the thread 14bolt FF size vs 10bolt.I think it’s NV261
-
BI’m swapping a 14bolt FF into a k5 Truck has a 4”lift and currently the slip yoke sits out pretty far. Drive shaft looks like it is 2-3...
-
-
BBryanS replied to the thread Replacing rear axle on 83 k5.OK About to pull the trigger on a 14 bolt FF with 4.10 and factory locker. Also a driveshaft from the suburban I need to have cut...
