Recent content by BryanS

  1. B

    14bolt FF size vs 10bolt

    Sorry here are the photos
  2. B

    14bolt FF size vs 10bolt

    So where I’m at now is just finding a d44 from 3/4 ton 8 lug and swapping the whole thing. I would do a 60 if I can afford it I see 44s for pretty cheap already with the 4:10s I’m looking for Can anyone tell what kind of diff this is? Open? locker? They say it’s hub to hub 8 lug. $400 plus...
  3. B

    14bolt FF size vs 10bolt

    Or drill new holes in the one I have?
  4. B

    14bolt FF size vs 10bolt

    Or can it be a Dana 44?
  5. B

    14bolt FF size vs 10bolt

    So I have to find a 2500 8 lug 10 bolt to raid for parts? Specifically the backing plate?
  6. B

    14bolt FF size vs 10bolt

    Next question. Not sure if this should be a different thread but it seems all the right people are looking at this one :) My front axle is 6 lug and I need to change that to 8 It is a 10 bolt. I’m thinking I can change the hubs and basicly be good to go? I’ll need to do the ring gear to...
  7. B

    14bolt FF size vs 10bolt

    Got it. That makes perfect sense
  8. B

    14bolt FF size vs 10bolt

    I may have seen the wrong numbers Is this the tag I should be looking at? The front shaft is on the correct (passenger) side Here are a couple pictures of the case Thank you guys
  9. B

    14bolt FF size vs 10bolt

    I think it’s NV261
  10. B

    14bolt FF size vs 10bolt

    I’m swapping a 14bolt FF into a k5 Truck has a 4”lift and currently the slip yoke sits out pretty far. Drive shaft looks like it is 2-3 inches too short. My question is the new diff is bigger. Does that mean the yoke on the diff is maybe 2 or three inches longer and then like magic my drive...
  11. B

    Replacing rear axle on 83 k5

    OK About to pull the trigger on a 14 bolt FF with 4.10 and factory locker. Also a driveshaft from the suburban I need to have cut down and balanced. Mine was too short anyway Out of 99 2500 suburban Need to move the spring perchs Also getting 8 lug wheels part of the deal. psyched :)
  12. B

    AN fittings need to be drilled?

    Thanks puffy I’ll look at them.
  13. B

    Reverse light options

    Move to a better state? FL has no inspections…at all
  14. B

    Hilly carb on edelbrock performer BBC

    Got it Thanks! PO set up with “regular” open square gasket. Blocking some of the opening. The truck idled crappy. Think this may have contributed to that?
  15. B

    Hilly carb on edelbrock performer BBC

    Hi team I have a 454 with a performer intake I’m changing the carb from a 600 holly to a 750 vac secondary The new (and old in place) gasket covers a decent amount of the intake opening. See photos Is this normal? Do the performers take a special gasket? Should I cut the gasket back so...
See more

Latest posts

Forum statistics

Threads
45,348
Posts
981,314
Members
38,375
Latest member
BrickBlazer
Top