75BEASTK20
Latest activity Postings About
-
-
75BEASTK20 reacted to 75gmck25's post in the thread K20 upgrades. EDELBROCK AVS II. Why so negative ? with
Like.
I have not looked at the Edelbrock 1906 AVS2 specs for rods/jets and springs, but maybe they richened it all up a little. Also, the... -
75BEASTK20 reacted to rich weyand's post in the thread K20 upgrades. EDELBROCK AVS II. Why so negative ? with Like.
I ran with the Edelbrock. I played with the springs to get the mixture change to kick in at the right spot. I also put an AFR meter on...
-
75BEASTK20 reacted to ali_c20's post in the thread K20 upgrades. EDELBROCK AVS II. Why so negative ? with Like.
I run a 500 cfm AVS2 on my K5 with a Goodwrench crate and TH350. Imo the best carb next to the Quadrajet. Easy to tune and great...
-
75BEASTK20 replied to the thread K20 upgrades. EDELBROCK AVS II. Why so negative ?.Nothing wrong with a really good tuned quadrahog. I just find the AVS so easy to tune. Change jets and metering rods in 5 min or less...
-
75BEASTK20 replied to the thread Need to replace rubber fuel lines on top of both tanks…..I had to measure and cut a little steel to fold back, to access the middle cab mount bolts. It has a caged nut in size and they are...
-
75BEASTK20 reacted to Dukester68's post in the thread Need to replace rubber fuel lines on top of both tanks…. with Like.
Done…
-
75BEASTK20 replied to the thread Need to replace rubber fuel lines on top of both tanks…..AND YES......it's definitely a good time to replace your one set of body bushing mounts.
-
75BEASTK20 replied to the thread Need to replace rubber fuel lines on top of both tanks…..Loosely cover tank(s) with a wet blanket underneath, to avoid sparks hitting any tanks after pumping out as much fuel as possible...
-
75BEASTK20 replied to the thread Steering Column needs to be rebuild.Here's the link for the columns at LMC if that helps...
-
75BEASTK20 replied to the thread Steering Column needs to be rebuild.I have a problem. I have a 1975 K20, factory power steering, with NO TILT COLUMN. I found the column at LMC. They list two. I am...
-
75BEASTK20 replied to the thread Throttle cable way too long.Luckily the truck was NEVER bent. If it was, I couldn't do it.
-
75BEASTK20 replied to the thread Throttle cable way too long.I think this will work............Once I get into it deeper. There may have to be some modifications ,but with fabrications I think it...
-
75BEASTK20 replied to the thread Throttle cable way too long.Thanks for that info. I have an old friend that is an excellent "fabricator". As well, I'll check salvage yards. Even if I can get...
-
75BEASTK20 replied to the thread Throttle cable way too long.But, as I cruise the salvage yards in Texas, I will check and if they do have a wood bed, I'll snag the supports just in case.
-
75BEASTK20 replied to the thread Throttle cable way too long.I spoke at length with LMC and ordered all new supports ext. to put the wood bed on. Looks like everything is there.
-
-
Loading…
-
Loading…
