BadBowtie
Latest activity Postings About
-
-
Any know where to find or repair module? -
Thank you all for input turns out I jumped module and pump worked so removed module and squirter works fine module controls delay and...
-
Thanks ill try next warm day
-
If I’m remembering correctly (not home currently to check diagram) the pnk wire goes back to wiper switch to ground wash pump when...
-
BadBowtie reacted to 84_c10_GMC's post in the thread One more electrical plug identification with
Like.
I do have a gauge and it’s the only wire left at this point that could go to the temp sensor. I just need figure out how to run it up to... -
BadBowtie reacted to gmbellew's post in the thread One more electrical plug identification with Like.
pretty sure green wire single connector is the temp sensor for the gauge between cylinders 1 and 3.
-
I looked at my ‘81 because that three wire connector looked familiar- the one that goes to the oil pressure switch to activate the choke...
-
BadBowtie reacted to Ricko1966's post in the thread One more electrical plug identification with Like.
No it's not. That's a universal type and I would bet you money it is a normally closed switch for a light. Do all three ports in that...
-
BadBowtie reacted to 84_c10_GMC's post in the thread One more electrical plug identification with Like.
The 3 wire one? It has a hold down for either the back of the head or bell housing. And wire harness said for oil sensor above filter.
-
BadBowtie reacted to Ricko1966's post in the thread One more electrical plug identification with Like.
I believe that one goes to a second oil pressure switch which controls power to your electric choke,no power to the choke if the engine...
-
BadBowtie replied to the thread 700r4 slipping in cold weather.Start adding Lucas Transmission Conditioner if you still need to add fluid. Transmission hot, level ground of course.....
-
Long time ago I went to a gas station I normally do not go to and short of it I got bad gas and then my truck would not shift and it is...
-
What did the spacer plate look like? Anytime I have a 700 or 4L60E apart, I plan on replacing the plate. The check balls beat the plate...
-
BadBowtie reacted to NickTransmissions's post in the thread 700r4 slipping in cold weather with Like.
Again, what are the results of your pressure testing? Stop guessing and do a pressure test so you know exactly where you stand. Let us...
-
BadBowtie reacted to NickTransmissions's post in the thread 700r4 slipping in cold weather with Like.
What are the results of your pressure test?
-
-
Loading…
-
Loading…
