AZ Highlander
Latest activity Postings About
-
-
AZ Highlander replied to the thread Headlight options for 84 K10.how are they holding up Zach? -
AZ Highlander reacted to Ricko1966's post in the thread Turbo350 w/shift kit slamming 2nd gear with
Like.
If you have the room. -
AZ Highlander replied to the thread Turbo350 w/shift kit slamming 2nd gear.The boys got it to seat. They're 15 and 17 and sure can wrench. As their homeschool auto shop teacher, they're getting to the point...
-
My '85 uses 11/32 from the vacuum port on the carb to brake booster check v/v. My understanding is that while 3/8 fits, 11/32 ends up...
-
Sorry for the lack of updates. Life, weather, and a wrong cable have slowed this project down. I found the real problem. My TV cable was...
-
AZ Highlander reacted to TotalyHucked's post in the thread NEW Brothers Dash Bezels - CHEAP with Like.
Holley purchased Brother's a few years back, Brother's only exists in a name now. Last I heard, they'd shut down the call/tech center in...
-
AZ Highlander reacted to Doppleganger's post in the thread NEW Brothers Dash Bezels - CHEAP with Like.
Not sure if you fellas saw these, but there is a vendor on Feebay that is blowing out Brothers dash bezels for cheap. Prices are $12 -...
-
AZ Highlander replied to the thread Turbo350 w/shift kit slamming 2nd gear.Thanks Matt and HotRod! Its a K25, so there's both an exhaust pipe AND a driveshaft there. Pretty tight prying. Gonna try to see if...
-
AZ Highlander reacted to Matt69olds's post in the thread Turbo350 w/shift kit slamming 2nd gear with Like.
Lube the seal with vasoline, place the o ring in the case, right up against the step it seals against. Lube up the cover, put it...
-
AZ Highlander reacted to HotRodPC's post in the thread Turbo350 w/shift kit slamming 2nd gear with Like.
Yep, Matt said the trick. Most people put that O ring over the cap and try to push it in place. NOPE. Put the O ring in the groove of...
-
AZ Highlander replied to the thread Turbo350 w/shift kit slamming 2nd gear.How do we get the accumulator cover back on? Can't figure out how to get the snap ring back in the groove while pushing on the cover...
-
Threaded rivets are ok. Don't use stainless as the sheet metal that is contact with them will rust very quick ( galvanic corrosion). Use...
-
AZ Highlander reacted to Chris64's post in the thread What have you done to your square lately?? with Like.
Oh let's see... * Finally got my timing about right. * It finally starts and runs great...and... * Starter stopped working - tapped it...
-
AZ Highlander reacted to Strick's post in the thread What have you done to your square lately?? with Like.
The filler neck ground attaches to the bed cross-rail. I'll get you more photos tomorrow when back at work. I'll post them here on this...
-
AZ Highlander reacted to JamesSam's post in the thread What have you done to your square lately?? with Like.
@Ricko1966 , @Strick Rick and Harold, I am not removing the bed when I drop the drivers tank on my 87 V10. Where is the eyelet ground...
-
-
Loading…
-
Loading…
Latest posts
-
-
-
-
-
Update: The surging stopped....took me by surprise- Latest: backwoodsman