fast 99
Latest activity Postings About
-
-
fast 99 replied to the thread Bench Seat Foam Fitment Options.Like me others have had very bad experiences with USA1, never again. -
fast 99 replied to the thread Fuel Valve Replaced.First thing that comes to mind is dirt. Check fuel filter, pump pressure and volume.
-
fast 99 replied to the thread 208 Milky fluid.Rather common, especially with front diffs that haven't been used enough. Condensation and no heat to burn water off. Water will usually...
-
fast 99 replied to the thread 1987 suburban tbi 350 overheating..Doubtful, in 30 years of repair work only seen a handful of bad impellers. Those were in heavily rusted systems, impellers were rotted...
-
fast 99 replied to the thread Cylinders washed need help.............and all it takes is one backfire to blow a PV. If it's a Holley PV is bad/leaking, to those who dislike Q jets joking. I...
-
The way a power valve works is at low vacuum conditions( the farther you are in the throttle the lower your vacuum readings) so when you...
-
fast 99 replied to the thread Cylinders washed need help.Go back to basics. Spark, fuel, timing by TDC and rotor position. If all checks out try a new set of plugs. Also check for 12V on choke...
-
fast 99 replied to the thread Cylinders washed need help.check fuel level/float/ idle mixture, running. Should be fuel just below opening, side of bowl. Accelerator pump only works during...
-
fast 99 replied to the thread Cylinders washed need help.It is possible to wash rings out of a new engine. Way rich, although probably no damage has been done yet need to fix whatever is...
-
fast 99 replied to the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work?.Install them, support for tranny case, very necessary for longevity.
-
fast 99 replied to the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work?.Short ones appear to be rear ac bracket or alt as someone else pointed out. They should go to intake studded bolts.
-
fast 99 reacted to nvrenuf's post in the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work? with
Like.
Jack the motor up and slip the brackets in like they are supposed to be. Those short bars look like a/c compressor braces, there might... -
fast 99 reacted to TotalyHucked's post in the thread Trans braces not installed when motor went in, can I fix with a little welding/fab work? with Like.
I would lift/jack the motor up and install the way they were intended
-
fast 99 replied to the thread Intake manifold to head port mismatch.I wouldn't think so. However, it would have more power [torque] with the correct intake.
-
fast 99 replied to the thread Intake manifold to head port mismatch.If it runs fine don't fix it. However, larger intake to smaller head port will be detrimental to performance. Square edge on head will...
-
-
Loading…
-
Loading…
