Rear axle shafts

[Logan Berube]

I am looking for rear axle shafts for a 8.6" carrier with a 30 spline axle and can't find any available anywhere. the length needed is 31 5/16" if you could give me suggestions on where some are that would be appreciated.

 

[Doppleganger]

I'm guessing for the 86 K10? Think there might be a couple in PnP's in Toledo. Probably be easier to procure an entire rear axle. 3.42? 3.73?

 

[Logan Berube]

It has the 3.73 in it and it is a k10 I already have the carrier and ring hers installed in the housing I just need the axles

 

[Shorty81]

Welcome Logan. I'm about 10 miles South of you.

 

[Nonstop]

Probably a bit late, but if you still need it, check rockauto under 1988 v10 Suburban. Dana 2022609.

 

[Curt]

Yukon,strange engineering,dts,offroad design,Randy’s ring and pinion................

 

[Catbox]

Dorman is a parts house brand and work just fine as well.
I just put one into my Suburban to replace the stock one with 225,000 on it.
It was just starting to wear through the hardening.

The other axle is from the junkyard and is still holding up well.