Old Detroit w/blower

[bucket]

Anyone know anything about this motor? Er... engine? Or where to find more info? It's in an old John Deere harvester.

You must be registered for see images attach

You must be registered for see images attach

 

[Honky Kong jr]

6 or 8? Probably a 6v71 71 iubic inches per cylinder 2 stroker

 

[bucket]

It's a 6. I thought that's what it might be, but wasn't sure. I don't know how old it is. My boss actually has two of these machines. This one ran, the other is incomplete.

 

[bucket]

I was kind of thinking, this engine in my K5 frame with my '92 Camaro body on it.

 

[Honky Kong jr]

I was kind of thinking, this engine in my K5 frame with my '92 Camaro body on it.

I have a K5 frame to donate to the cause come get it free just missing the front axle shafts. Then I won’t have to cut it up. That would be awsome

 

[74propu]

V6-71 they are hi rpm power band engs NO power at lower rpms . Still lots of parts available for them Cheep to rebuild . I have drove trucks with them . best way to drive it is open the door put your fingers in the door and slam it on your fingers then get in the truck and drive it pissed

 

[MrMarty51]

Two stroke Detroit, screaming Jimmy.
That`ll definitely pull the K5 with the Camaro body.
These engines are air cooled from the wind blowing through the block, only coolant is in the cylinder heads.
Running the rack to tune them up is easy.
You might want to pack along some hearing protection when driving it.
Please build this unit.

 

[da_raabi]

I've had wet dreams over a 6-71 in a square for a long long time. They just sing. Even a 4-71 or even the little 4-53 would be fun as hell too!

xc_hide_links_from_guests_guests_error_hide_media

 

[bucket]

Awesome. I'll start buttering up the boss so I can hopefully get my hands on one of them.

It sounds like a manual trans would be the way to go. Anyone know offhand what bellhousing bolt pattern this is? Looks like it's the bigun' for a large truck. Any way to run a common trans behind it, like an SM465?

 

[Honky Kong jr]

Awesome. I'll start buttering up the boss so I can hopefully get my hands on one of them.

It sounds like a manual trans would be the way to go. Anyone know offhand what bellhousing bolt pattern this is? Looks like it's the bigun' for a large truck. Any way to run a common trans behind it, like an SM465?

As long as those have been around I’m sure. Definitely would want a GV on the back of that combo. Look for a SAE#2 pattern adapter.

 

[78C10BigTen]

I've had wet dreams over a 6-71 in a square for a long long time. They just sing. Even a 4-71 or even the little 4-53 would be fun as hell too!

xc_hide_links_from_guests_guests_error_hide_media

Now thats what it means to be a truck driver!!! Holy hell

 

[Honky Kong jr]

Now thats what it means to be a truck driver!!! Holy hell

Put a Swift driver in one of them in a crowded parking lot. Lmao

 

[78C10BigTen]

Put a Swift driver in one of them in a crowded parking lot. Lmao

Lmao wed all be dead! I see the actions of swift drivers daily

 

[78C10BigTen]

I got youtube vid hoppin from that one and come to find alot of squares with these engines and twin sticks...