Inner Rocker, Outer Rocker, Inner Cab Corner, Kick Panel & Floor Replacement

[Tank6x2]

These replacement body panels sometimes are just bloody ignorant! Slowly working the cab corner all the way around and then had a bulge in the bottom, couple of relief cuts and slow manipulation and managed to get the panel placed and aligned the way I was looking for.

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[Tank6x2]

I had this same issue with my drivers side cab corner but relief cuts allow the manipulation of the panel.

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[Tank6x2]

Slowly it’s getting there! 90% done tack welding...

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[Tank6x2]

Little more done today, it’s a slow process...

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[Tank6x2]

Finished!! ....well welding

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[RoryH19]

Nice work. Reminds me of my k5 build but without cab corners.
With all those spot welds it will be 10x stronger than factory.

BTW, I still owe you a pic of the lowered dually I mentioned the other day. It wasn't there when I went to take a pic but I'm sure it will be back soon.

 

[Tank6x2]

Nice work. Reminds me of my k5 build but without cab corners.
With all those spot welds it will be 10x stronger than factory.

BTW, I still owe you a pic of the lowered dually I mentioned the other day. It wasn't there when I went to take a pic but I'm sure it will be back soon.

Can’t control where the truck goes Bubba, you’ll get it one day!

 

[COREY TREVOR]

nice work man , gonna be doing this soon to my truck for first time , its very nice to see all these photos of somebody doing it the right way .

 

[Tank6x2]

nice work man , gonna be doing this soon to my truck for first time , its very nice to see all these photos of somebody doing it the right way .

Thanks bubba!