Now THIS is information we can use! My first thought was a clay bar.
The P.S. bracket low-down.
First off, thank you for the compliments.
The ps bracket started out as 2-1/2" x 2-1/2" x 12" square aluminum bar. I carved it down from there. That took about 4 hours of manual machine work. (Not rushing). I have years of manual and CNC machine experience and I'm way older than the truck. I figure my time, on a manual machine is worth $50/hr. not counting material cost.
The bracket kit from summit was $45. And that was cut on a CNC, tumbled , and shipped. It probably took a total of 5 minutes cycle time from start to completed part, if that long.
I don't know of 1 single person that would pay a guy $200.+ for that bracket, when $45. options are out there.
It's all about "what's the least expensive"...
I had the material in my stash and it was raining cats-n-dogs, so I had nothing better to do than cuss the weather.
A guy can't break even making parts in his garage.
But I do appreciate the kudos. Thanks.