Factory smoke

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

gerhed

Full Access Member
Joined
Jul 7, 2024
Posts
62
Reaction score
165
Location
Kentucky
First Name
Jason
Truck Year
1983
Truck Model
K20
Engine Size
350
Right, so I was putting the battery in and while shooting the poop with a friend and me, being overconfident, hooked the battery up backwards, lol. I found the fusible link and slapped and inline fuse holder I had and stuck a 30 amp fuse in it so I could get things running, which I did, and it runs great, lol. Starts immediately, brakes work, clutch fine, parking brake works, everything, except a few gauges, like the temp and battery gauge. All the fuses are good, so I'm wondering if I fried the gauges with the reversed polarity battery. Any suggestions would be greatly appreciated. TYIA
 

fast 99

Full Access Member
Joined
Dec 31, 2021
Posts
2,086
Reaction score
3,053
Location
Spokane, Washington
First Name
Brian
Truck Year
81,85
Truck Model
K20
Engine Size
350
Hooking up a battery backwards can cause all sorts of electrical gremlins. Yes, it's possible damage was done to either the wiring or gauge itself.
 

75gmck25

Full Access Member
Joined
Oct 13, 2016
Posts
2,302
Reaction score
2,271
Location
Northern Virginia
First Name
Bruce
Truck Year
1975
Truck Model
K25 Camper Special TH350 NP203
Engine Size
5.7
Hooked cables up backwards on my ‘75 (why did GM factory use black cables for both?), and all it did was burn the fusible link that is connected to the junction on the firewall next to the brake booster. It all worked fine once I replaced the link and corrected the cable polarity.

Mine was only connected for a very short time (it started smoking immediately), and my ‘75 has an amp gauge not a voltmeter. Maybe I just dodged a bullet when it didn’t damage anything.
 

YakkoWarner

Full Access Member
Joined
May 29, 2024
Posts
185
Reaction score
244
Location
Central Texas
First Name
Wolf
Truck Year
1989
Truck Model
R2500 Suburban
Engine Size
454
Whenever I disconnect/reconnect a battery I always hook up one side then give the other one a very quick tap on the terminal without actually putting it around (for a top post) or screwing it in (for a side post). That way if I see any kind of arc I know something is wrong and its only had a fraction of a second of current. Also do the same thing if jumpering another vehicle even though a bit of spark is expected there - if you get a big crackling arc you know not to proceed.
 

PrairieDrifter

Full Access Member
Joined
Dec 28, 2014
Posts
3,875
Reaction score
5,703
Location
North Dakota
First Name
Mason
Truck Year
84,79,77,76,70,48
Truck Model
Suburban k10, bonanza k10, k30, k20, c10, gmc 1/2ton
Engine Size
350, 350, 350, 350, 350, 350
There's two or three fusible links down there. Did you check them all? Check fuses too.
 

Radiohead

That guy on the Columbia
Joined
Mar 17, 2022
Posts
2,488
Reaction score
8,118
Location
Low Earth Orbit where it's safer
First Name
Eric
Truck Year
MCMLXXIX
Truck Model
C-20 Silverado Camper Special
Engine Size
454 crazy cubes, or 7.4 luscious litres
It's your lucky day! Looks like new stock has finally arrived.
You must be registered for see images attach


Now, a little known life hack that just might save your bacon after the unplanned polarity shift was installed. Saves having to convert the system, you can just pour and go.
You must be registered for see images attach
 

Turbo4whl

Supporting Member
Supporting Member
Joined
Oct 30, 2019
Posts
3,154
Reaction score
7,320
Location
Downingtown, PA
First Name
Wayne
Truck Year
1974
Truck Model
Jimmy
Engine Size
350
There is a possibility that the alternator didn't enjoy the reverse feed either. So the engine will run off the battery, but did you check the running voltage to see if the alternator is charging?
 

gerhed

Full Access Member
Joined
Jul 7, 2024
Posts
62
Reaction score
165
Location
Kentucky
First Name
Jason
Truck Year
1983
Truck Model
K20
Engine Size
350
Took the alternator to the parts store and had it tested, it checked out fine. Other fusible links checked out. Only the temp and volt gauges quite working, so I ordered a couple new ones. We will see what's up after they get put in. I'm expecting to replace some bulbs too., I know a have a backup light out and the high beam indicator is out.
 

gerhed

Full Access Member
Joined
Jul 7, 2024
Posts
62
Reaction score
165
Location
Kentucky
First Name
Jason
Truck Year
1983
Truck Model
K20
Engine Size
350
It's your lucky day! Looks like new stock has finally arrived.
You must be registered for see images attach


Now, a little known life hack that just might save your bacon after the unplanned polarity shift was installed. Saves having to convert the system, you can just pour and go.
You must be registered for see images attach
The perfect response.
 

Craig Nedrow

NADAR UNDER THE RADAR
Joined
Sep 1, 2018
Posts
1,094
Reaction score
2,332
Location
Washington State
First Name
Craig
Truck Year
1973 (have two), 1985
Truck Model
K10, K20, C20
Engine Size
350, 454, 6.2 Detroit
It's your lucky day! Looks like new stock has finally arrived.
You must be registered for see images attach


Now, a little known life hack that just might save your bacon after the unplanned polarity shift was installed. Saves having to convert the system, you can just pour and go.
You must be registered for see images attach
Geez Eric, your heading to the dark side where Rustynail dwells
 

Radiohead

That guy on the Columbia
Joined
Mar 17, 2022
Posts
2,488
Reaction score
8,118
Location
Low Earth Orbit where it's safer
First Name
Eric
Truck Year
MCMLXXIX
Truck Model
C-20 Silverado Camper Special
Engine Size
454 crazy cubes, or 7.4 luscious litres

YakkoWarner

Full Access Member
Joined
May 29, 2024
Posts
185
Reaction score
244
Location
Central Texas
First Name
Wolf
Truck Year
1989
Truck Model
R2500 Suburban
Engine Size
454
It's your lucky day! Looks like new stock has finally arrived.
You must be registered for see images attach


Now, a little known life hack that just might save your bacon after the unplanned polarity shift was installed. Saves having to convert the system, you can just pour and go.
You must be registered for see images attach

Woo hoo! I'm trying to reassemble an MGB - that stuff could be a lifesaver! And its genuine Lucas so you know its been approved by the Prince of Darkness.
 

JBswth

Full Access Member
Joined
Jan 24, 2022
Posts
236
Reaction score
194
Location
Vallejo, California
First Name
James
Truck Year
1973
Truck Model
C25
Engine Size
292 cubic inches
There is a possibility that the alternator didn't enjoy the reverse feed either. So the engine will run off the battery, but did you check the running voltage to see if the alternator is charging?
A quick way to see of the alternator is working is to see if the back of the rear bearing cover is magnetized when engine is running - strong magnet, it is good. Weak or not magnetic, bad alternator.

J. B.
 

Forum statistics

Threads
44,391
Posts
956,266
Members
36,679
Latest member
86C25
Top