exhaust manifold donut

[Layne02]

Have old exhaust off so trying to post pictures of the donut. You can see it is molded on inside to go over manifold. Anybody recognize ?

You must be registered for see images attach

You must be registered for see images attach

 

[yevgenievich]

The regular factory one is similar once you knock the piece of pipe out.

 

[Layne02]

Theses are the originals. What do you mean knock the piece of pipe out?

 

[Layne02]

O wait, you mean that there is sleeve that may be stuck in manifold that separated from gasket?

 

[yevgenievich]

O wait, you mean that there is sleeve that may be stuck in manifold that separated from gasket?

Correct

 

[Layne02]

Gotcha, that explains a lot, thanks a million.

 

[smoothandlow84]

Hooray!

Yup...headers...!!

 

[Honky Kong jr]

Yup...headers...!!

That will fix the donut dilemma for sure. And suggested in post 2 lol

 

[Layne02]

Yevgenievich was right, went out today and looked, and sure nuff, there was the sleeve stuck in each side. Thanks again

 

[Honky Kong jr]

Yevgenievich was right, went out today and looked, and sure nuff, there was the sleeve stuck in each side. Thanks again

He’s usually good like that.

 

[yevgenievich]

Yevgenievich was right, went out today and looked, and sure nuff, there was the sleeve stuck in each side. Thanks again

The replacement gasket usually comes with the sleeve if you are getting new ones

 

[Layne02]

Yes sir, have them on the way, hope to install this weekend.

 

[Keith Seymore]

Headers for all!

...

You must be registered for see images attach