EFI Conversion

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Goodle17

Junior Member
Joined
Feb 6, 2023
Posts
2
Reaction score
1
Location
langdon alberta
First Name
Tyler
Truck Year
1981
Truck Model
K1500
Engine Size
350
I’m looking at adding an EFI to my 350 as opppsed to the LS Swap. I’m essentially looking for better fuel economy. For the guys who have done this… is it worth the additional cost? I’m seeing units between $900-1500 so I’m curious if it’s worth the money or if I just go ahead and opt for the swap. Any insight for info would be appreciated. I also have duel tanks if that matters? I’m not much of a mechanic lol
 

Ricko1966

Full Access Member
Joined
Apr 11, 2017
Posts
5,446
Reaction score
8,683
Location
kansas
First Name
Rick
Truck Year
1975
Truck Model
c20
Engine Size
350
I'll put a link to a modded tbi truck, You didn't give us much info year,transmission,gearing. TBI could be sourced pretty cheap from the bone yard. But IMHO a properly tuned quadrajet is going to be less trouble less money and almost as good mpg wise. Milage I'd go long tube headers,electric fan,and under drive pulleys. Overdrive transmission and conservative rear gears. Here's the link for the tbi truck
 

DrvnDrvr

Full Access Member
Joined
Jan 30, 2022
Posts
170
Reaction score
506
Location
Central Oregon
First Name
Al
Truck Year
78
Truck Model
K20
Engine Size
350
Ive been looking for the same upgrade to my 78 350 4WD K20.

I think Rick is spot on with properly tuned quadrajet is going to be less trouble less money and almost as good mpg wise. Overdrive transmission and conservative rear gears.

There is no quick fix to better fuel mileage on these squares.
10-12 mpg is all your gonna get.

Any mod IF IT WORKS is expensive and a poor return on your investment. MPG wise.

Squares are what they are.
 

Goodle17

Junior Member
Joined
Feb 6, 2023
Posts
2
Reaction score
1
Location
langdon alberta
First Name
Tyler
Truck Year
1981
Truck Model
K1500
Engine Size
350
I'll put a link to a modded tbi truck, You didn't give us much info year,transmission,gearing. TBI could be sourced pretty cheap from the bone yard. But IMHO a properly tuned quadrajet is going to be less trouble less money and almost as good mpg wise. Milage I'd go long tube headers,electric fan,and under drive pulleys. Overdrive transmission and conservative rear gears. Here's the link for the tbi truck
Thank you. It’s a 1981, with a 350, K1500. It’s stock and stock can get minus headers. The old boy I bought it off used it as an everyday farm truck and it’s been parked for the last 10 or so years. I’m not even sure what transmission is in it yet. What I do know, is she’s a gutless 350 which is in desperate need of a tune up. After doing some reading, I started looking into the LS Swap, or the EFI route. I’ve definitely considered a new carburetor as well. I didn’t realize there were so many options when it comes to these things.
 

Ricko1966

Full Access Member
Joined
Apr 11, 2017
Posts
5,446
Reaction score
8,683
Location
kansas
First Name
Rick
Truck Year
1975
Truck Model
c20
Engine Size
350

Ricko1966

Full Access Member
Joined
Apr 11, 2017
Posts
5,446
Reaction score
8,683
Location
kansas
First Name
Rick
Truck Year
1975
Truck Model
c20
Engine Size
350
Thank you. It’s a 1981, with a 350, K1500. It’s stock and stock can get minus headers. The old boy I bought it off used it as an everyday farm truck and it’s been parked for the last 10 or so years. I’m not even sure what transmission is in it yet. What I do know, is she’s a gutless 350 which is in desperate need of a tune up. After doing some reading, I started looking into the LS Swap, or the EFI route. I’ve definitely considered a new carburetor as well. I didn’t realize there were so many options when it comes to these things.

First get it running and tuned then we'll see what we have to work with.
 

SquareRoot

Full Access Member
Joined
Mar 18, 2017
Posts
4,192
Reaction score
8,030
Location
Arizona
First Name
Mike
Truck Year
85
Truck Model
K20
Engine Size
350
I put sequential port EFI (Edelbrock Pro-flow 4), an NV4500, electric fans and much more on my 85. Cheap? Hardly. But, it starts and runs like a modern vehicle. The OD trans shifts silky smooth and cruises 70 mph at 2300 rpm. On average the mpg is 10 city, 15 highway. Was it worth the money....nope. But it was worth the experience. Would I do it again.. nope. I'd put a factory LS with OD in it and be done with it.
 

75gmck25

Full Access Member
Joined
Oct 13, 2016
Posts
2,263
Reaction score
2,206
Location
Northern Virginia
First Name
Bruce
Truck Year
1975
Truck Model
K25 Camper Special TH350 NP203
Engine Size
5.7
If you don’t want to use the stock Quadrajet, the Edelbrock AVS 2 carburetor has a good reputation for a daily driver, and is supposed to be a big improvement in low speed driveability over the older 1406.

I’m not knocking Quadrajets (I have one on my truck), but by the time you buy a high quality rebuild kit and do a full rebuild (throttle shaft bushings, etc,) it gets close to the price of a new Edelbrock.
 

Ricko1966

Full Access Member
Joined
Apr 11, 2017
Posts
5,446
Reaction score
8,683
Location
kansas
First Name
Rick
Truck Year
1975
Truck Model
c20
Engine Size
350
If you don’t want to use the stock Quadrajet, the Edelbrock AVS 2 carburetor has a good reputation for a daily driver, and is supposed to be a big improvement in low speed driveability over the older 1406.

I’m not knocking Quadrajets (I have one on my truck), but by the time you buy a high quality rebuild kit and do a full rebuild (throttle shaft bushings, etc,) it gets close to the price of a new Edelbrock.
And when his qjet is right its right its not a one size fits all and works okay. All quadrajets are not the same,they are set up for the application. Lots of variables with a qjet. Kinda like they correct distributor vs. A one size fits all distributor.
 

memo43

Junior Member
Joined
Nov 26, 2017
Posts
5
Reaction score
3
Location
89460
First Name
Memo
Truck Year
1985
Truck Model
k20
Engine Size
350 (l31 roller motor)
Agreed with all the responses.
I Installed a summit max efi system to my 85 k20
"was" stock 350/th400 combo with 4:10 gears.
I had the stock Qjet tuned and optimized.

Issue I had is I live at 4300 feet and work at 7200, I was getting about 10-12mpg.
After my 350 was getting tires I swapped an L31 along with the EFi. Now my rig starts every time and is as reliable as my 09 silverado.
I now avg 14-15 mpg my 09 gets 19-20 (has a 4L60 trans)
Do I recommend it, "Yes". Is it as good or better than an LS "Depends". It definitely is a cheaper alternative I'm all in for roughly 1300.
an LS would have been 3500 (all the nickel and dime.)
Ways to improve get an OD trans and gear appropriately.
Don't let the MPG discourage you
look at new trucks an see what they are getting.

Any more question just ask
 

TPISly-C10

Full Access Member
Joined
Apr 1, 2019
Posts
615
Reaction score
883
Location
Boucherville QC Canada
First Name
Sly
Truck Year
1986
Truck Model
C-10 shortbox
Engine Size
LQ4 6.0L
love my 20mpg $500 6l LS so easy to swap and so much power and reliablitie! :)
 

Attachments

  • _SLY5497.jpg
    _SLY5497.jpg
    120.6 KB · Views: 97

Rumbledawg

Full Access Member
Joined
Jul 15, 2021
Posts
269
Reaction score
1,021
Location
the back 40
First Name
Dan
Truck Year
1985
Truck Model
K30 crewcab
Engine Size
454
depends on where you live. being out in the flatlands, a well tuned carb would do fine.
i put efi in my truck cause i live in the mountains, doesn't matter if i'm at sea level or 8000ft up, runs the same all day whatever the altitude. plus being a 4x4, i have no off camber starvation issues that i used to get with a carb, plus vapor lock is nonexistent with fi.
doubt you'll see any significant mpg's increase, what you will see with efi is a better all around driver. no pumping the throttle or choking it, just reach in and fires up like a modern truck. efi will also start faster and easier in sub zero weather than any carb. i've made the cost worthwhile in my truck caused i fuel injected my truck 20 yrs ago, so i imagine it's prob paid for itself by now....
only time i would go back to a carb would be for a period correct build, other than that, fi all the way
 

Latest posts

Forum statistics

Threads
44,160
Posts
950,626
Members
36,273
Latest member
dannyphx
Top