Dual Tanks Fuel switch delete

[1974Blueflame]

I have a fuel switch issue and don’t really want to have to switch between tanks has anyone just configured the hoses into a T going to the fuel pump?

 

[WFO]

I have a fuel switch issue and don’t really want to have to switch between tanks has anyone just configured the hoses into a T going to the fuel pump?

I did on a 1980 company truck, while doing a job out of town. Worked fine for the couple of months it took to finish the job, then fixed it when we got back home.
The tanks will equal out, and the gauge was the most accurate after it had been parked for a while.

 

[Grit dog]

I have a fuel switch issue and don’t really want to have to switch between tanks has anyone just configured the hoses into a T going to the fuel pump?

No return line(s) that will work. 3 port sender and return line fuel pump, that will not work.

 

[WFO]

No return line(s) that will work. 3 port sender and return line fuel pump, that will not work.

Worked for me. I don't make this stuff up.
Didn't even mess with the return line. I reckon it only returned to the one tank that had been previously switched to, but the tanks equalized themselves anyway.

 

[bucket]

Worked for me. I don't make this stuff up.
Didn't even mess with the return line. I reckon it only returned to the one tank that had been previously switched to, but the tanks equalized themselves anyway.

So you are saying that with the supply lines tee'd together, the tanks balanced due to a siphon effect through the supply line? Makes sense.

I'm sure there's going to be a scenario where that setup could possibly cause an issue though, if someone did it that way permanently.

 

[Ricko1966]

So you are saying that with the supply lines tee'd together, the tanks balanced due to a siphon effect through the supply line? Makes sense.

I'm sure there's going to be a scenario where that setup could possibly cause an issue though, if someone did it that way permanently.

It's going to cause an issue eventually if/ when 1 tank runs low enough to lose prime and siphon effect. NBD I just don't want to be the guy adding fuel to the low tank at the side of the road.

 

[CalSgt]

It's going to cause an issue eventually if/ when 1 tank runs low enough to lose prime and siphon effect. NBD I just don't want to be the guy adding fuel to the low tank at the side of the road.

^^^ This

If the system would work well without a selector valve GM wouldn’t have spent the money putting them in.

If you need to hack it to get by for a while, then so be it.

Whichever tank has less resistance to pull the fuel from may end up getting ran dry faster than the other. When my selector valve went bad it pulled from both tanks, too many times one tank would run dry and would not even be able to start unless I primed the carburetor even after adding gas to the empty tank.

You’re better off replacing or repairing the selector valve (common failure), switch, or wiring.