dash gauge bezel mods

[496bb]

Anybody still doing the Autometer gauges in the factory bezel, with new ideas for such? I have a 90% complete set of new guages, and a spare bezel. Trying to avoid spending the high $$ for the various pre-packaged setups for our trucks. Gloshift isn't so bad at about $650 ish, but, the speedo has no odometer.

I'm not too concerned about the whole "gauges need to be angled up" argument. After searching posts on numerous forums over the years, I'm wondering if anyone has taken advantage of the newer 3D printing options to make some bracketry to hold the gauges in.

 

[nvrenuf]

I put all Autometer gauges in my bezel plus a couple of extras. Mine was easy as I don’t have any “guts” in my dash, the job would probably be pretty tricky if you had to worry about the depth because of hvac, etc.

You must be registered for see images attach