Cluster install for DUMMIES...help

[MikeB]

I spent a lot of time making sure I got mine right when installing a new universal wiring harness.

This might help somewhat:

You must be registered for see images attach

You must be registered for see images attach

Also, I found this Painless manual to be very helpful on everything electrical:

https://www.painlessperformance.com/Manuals/20205.pdf

 

[Jwernatl]

wow - you guys rock. Thank you- That painless manual pretty good for sure!

 

[ptfw30]

Did you check out the install videos that Classic has on their tech page? On the menu bar click on Tech Info and on the left they have Installation Videos Install Articles and Wiring Diagrams...hope this helps

 

[Jwernatl]

Did you check out the install videos that Classic has on their tech page? On the menu bar click on Tech Info and on the left they have Installation Videos Install Articles and Wiring Diagrams...hope this helps

I did, but, maybe i missed it. Ill look again. I need a 'step by step' that expalains it.

Actually, I need to take a class on AUTOelectronics. I know enough to burn something up. Its crazy, I can rebuild a carburetor, an engine etc, etc...but rewire my guage cluster Im afraid.

Ive tried to take a beginners course on 'auto-electronics', at one of our local colleges. They wanted 4 years, i wanted to learn how to rewire an old Jeep. (Really, i wanted to learn what NOT to do)

Im goimg to give it one more shot this weekend. I suck at auto electronics.

I would even pay for someone to teach me how to do it properly.

Thanks again.

 

[Turbo Dog]

Don't get over worried about it...remember just one wire/circuit at a time. Print a copy that you don't mind writing on and cross each of the circuits off as you complete them. I will be passing by close enough to stop for about an hour mid day on Thursday the 28th. I can answer questions and point out some things, no money needed.

I will be sleeping in Oxford, AL and heading for Willachoochee, GA. Is there a way you can send me your contact info on this site? Here is the route that I think is passing close by you (the blue route).

You must be registered for see images attach

 

[TrybalRage]

When I hacked apart my cluster I sat down with the original and traced the lines on the flexible circuit board. On a piece of graph paper I drew a rectangular box representing the electrical connector and labeled each square according to where the line went (temp / oil press / L turn / R turn / Power / Ground). Then you can figure out which ones go where for your new cluster.

I was then able to cut the connector off after labeling all the wires.

 

[CM1Dinger]

I know this thread is a bit old but I pulled some much needed good information off of it! Thank you to everyone who posted diagrams and links yall are the true heros.