Blinker problems

[75squarebody]

ok trying to make since of this the turn signal cam was broke on my 75 so I changed it left side turns work great right sides work good until you put on the brake then they stay solid until you take your foot off the brake any ideas did I do something wrong putting the steering wheel back on any ideas?

 

[C10MixMaster]

ok trying to make since of this the turn signal cam was broke on my 75 so I changed it left side turns work great right sides work good until you put on the brake then they stay solid until you take your foot off the brake any ideas did I do something wrong putting the steering wheel back on any ideas?

I would start with checking the grounds at the RR tail light.

 

[eskimomann209]

Mine did something similar and it was an issue with the HEADLIGHT wiring. Over current in the system is a huge issue here.
Make sure your blinker bulbs are all working.

 

[75squarebody]

Mine did something similar and it was an issue with the HEADLIGHT wiring. Over current in the system is a huge issue here.
Make sure your blinker bulbs are all working.

They work fine as long as you are not on the brake if you get on the brake pedal then the right side just goes solid.

 

[Doppleganger]

Sounds like a short / back feed.

Like C10MixMaster said - check the grounds, and even the power source at your switch. Thats the 'connections' (no pun intended) between a turn signal and brake lamp. I would use a continuity tester on a DVOM and see what circuit(s) are connected that shouldn't be.

 

[42Grand]

I'm surprised nobody has mentioned blinker fluid yet...