Bed side seam sealer

[Mlcdc1]

just finished installing new bed sides on my '77 and looking for recommendations for a good bed sealer to fill the seam with the floor that's user friendly - suggestions?

 

[Honky Kong jr]

just finished installing new bed sides on my '77 and looking for recommendations for a good bed sealer to fill the seam with the floor that's user friendly - suggestions?

I used this.

You must be registered for see images attach

 

[B.K. Cunningham]

I used dap sealer. Simelar to this.

You must be registered for see images attach

 

[Honky Kong jr]

If you would use the Gorilla stuff wear gloves it's like herpes once it's on you it stays on you. Lol

 

[Craig 85]

Eastwood sells it.

http://www.eastwood.com/eastwood-seam-sealer-cartridge.html
http://www.eastwood.com/ew-brush-on-seam-sealer-quart.html

 

[Honky Kong jr]

Eastwood sells it.

http://www.eastwood.com/eastwood-seam-sealer-cartridge.html
http://www.eastwood.com/ew-brush-on-seam-sealer-quart.html

That stuff is for the rich and naive.lol It's the same as the Gorilla stuff and twice the price plus shipping.lol just my .02

 

[Craig 85]

I had used the brush on product for a '64 Cutlass about 10 years ago. I did a full trunk floor patch. It covered the weld nicely and looked factory. Once dried, it felt just like the factory seam sealer. Honky kong Jr, I'm going to media blast my bed before paint. How's the texture of the Gorilla product once dry?

 

[Honky Kong jr]

I had used the brush on product for a '64 Cutlass about 10 years ago. I did a full trunk floor patch. It covered the weld nicely and looked factory. Once dried, it felt just like the factory seam sealer. Honky kong Jr, I'm going to media blast my bed before paint. How's the texture of the Gorilla product once dry?

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

If you took your time it would look better then mine but well this is by no means a show truck. Hope these answer your question.

 

[cooperhw]

I like the 3M brand seam sealer.

 

[Rakkasan]

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

If you took your time it would look better then mine but well this is by

I used this.

You must be registered for see images attach

Old thread revival.

Any ideas how many tubes will be needed to reseal the whole bed. I just got thru welding in my factory fuel door to relocate for my blazer tank and noticed half the factory sealer is gone.

Thx