pbcasterlin
Member
- Joined
- Apr 18, 2024
- Posts
- 37
- Reaction score
- 50
- Location
- Arizona
- First Name
- Paul
- Truck Year
- 1987
- Truck Model
- K10 Stepside
- Engine Size
- 350
Another seat belt question
- Thread starter pbcasterlin
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
pbcasterlin
Member
- Joined
- Apr 18, 2024
- Posts
- 37
- Reaction score
- 50
- Location
- Arizona
- First Name
- Paul
- Truck Year
- 1987
- Truck Model
- K10 Stepside
- Engine Size
- 350
Even better would be if someone could post a picture of the shoulder belt bolted into the "B" pillar with the plastic cover removed. I just want to make sure I am not missing anything.
Torrey
Junior Member
- Joined
- Nov 5, 2020
- Posts
- 5
- Reaction score
- 20
- Location
- Tulsa
- First Name
- Torrey
- Truck Year
- 1986
- Truck Model
- C10
- Engine Size
- LS
I think I ran into the same issue as you using the LMC three point belts. The hardware they send with the retainer was much smaller than my factory bolt. I used the factory bolt, but there was about a 1/4" gap between the belt "triangle" the head of the bolt and my interior trim. I ended up using a rubber grommet just to keep it from rattling.
