84 k5 Stock fuel Guage stuck on 1/4 tank???

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

123jerryeric

Junior Member
Joined
Nov 28, 2024
Posts
5
Reaction score
0
Location
27371
First Name
Jerry
Truck Year
84
Truck Model
K5
Engine Size
350
Hello! I need some help! I'm stumped! 84 gmc k5 blazer. Initial issue was tired of my gas guage only reading 1/4 or less. I put a new sending unit that checks out correct on ohm reading correctly (0-90). Also I have good 12v power to guage. both solid grounds and my pink wire running from sending unit to guage seems to look good. Guage itself checked correctly too (pegging over full when removing sending wire) and shows 90 ohms on multi meter when checking guage by itself. both my old fuel and new sending unit reading good but both only read 1/4 tank on guage.and all good power and grounds and I still CAN NOT get it to read over 1/4 tank no matter what!! Seems all the stuff is checking out like it's supposed to. What is my issue??
 
Last edited:

123jerryeric

Junior Member
Joined
Nov 28, 2024
Posts
5
Reaction score
0
Location
27371
First Name
Jerry
Truck Year
84
Truck Model
K5
Engine Size
350
This is the initial forum I been looking at but I can't find it again to reply on it
 

Attachments

  • Screenshot_20241128_104526_Chrome.jpg
    Screenshot_20241128_104526_Chrome.jpg
    86 KB · Views: 4

77Dmax

Member
Joined
Nov 10, 2024
Posts
45
Reaction score
92
Location
vt
First Name
Joe
Truck Year
1977
Truck Model
c20
Engine Size
6.6
Does it peg to empty if you ground the sender wire? Thats more important than going to full unplugged..
 

123jerryeric

Junior Member
Joined
Nov 28, 2024
Posts
5
Reaction score
0
Location
27371
First Name
Jerry
Truck Year
84
Truck Model
K5
Engine Size
350
I just went out and double checked. If I take groun wire loose from sending unit to frame it still reads 1/4. If I take the red wire off fuel sending unit it pegs full. So even with ground wire not attached to sending unit it still reading 1/4. Even if I move it with my finger it goes right back to 1/4 even with that one ground completely off
.
If I keep ground hooked up, and ground out the sender wire it does drop to E. Put sending wire back on the post and right back to 1/4 tank.
 
Last edited:

123jerryeric

Junior Member
Joined
Nov 28, 2024
Posts
5
Reaction score
0
Location
27371
First Name
Jerry
Truck Year
84
Truck Model
K5
Engine Size
350
If I keep ground hooked up, and ground out the sender wire it does drop to E. Put sending wire back on the post and right back to 1/4 tank. OH YEAH! And According to how much gas I seen in it (3/4 tank) when i had sending unit out and what the sending unit reads in ohms ( about 65ohm) which means right at about 3/4 tank also. So I know for a fact there is well over 1/4 tank of fuel in the tank as I'm doing all this testing. I've watched countless YouTube videos of the whole system and I can not figure it out.
 
Last edited:

Latest posts

Forum statistics

Threads
44,213
Posts
951,910
Members
36,360
Latest member
easy19
Top