4x4 5.3 swap adapter plates?

[Nicklepage1010]

I made these adapter plates using plans I found online. Is anyone else using this style mount?

You must be registered for see images attach

I guess what I'm wondering is will they work?

 

[MadOgre]

You should post those plans up so all can see

 

[Nicklepage1010]

I'm pretty sure they're generic 350 clamshell to ls adapters. I don't know if the engine needs to come forward at all

But this is what I used

You must be registered for see images attach

 

[Nicklepage1010]

So these mounts will NOT work. I'm working on a set right now. When they're done I'll post the plans for you guys that don't feel like spending 100$ on a set of mounts.

 

[Nicklepage1010]

You must be registered for see images attach

This is where I'm at right now. Once these are cut down a bit and welded together I'll post the measurements. These mounts will be used for swapping an lm7 5.3l into a 4wd k10 (stock height) and mated up to a TH350 transmission without having to move any if the drivetrain.

 

[foamypirate]

You must be registered for see images attach

This is where I'm at right now. Once these are cut down a bit and welded together I'll post the measurements. These mounts will be used for swapping an lm7 5.3l into a 4wd k10 (stock height) and mated up to a TH350 transmission without having to move any if the drivetrain.

Awesome, nice work there. Always glad to see people willing to share their work with the community!

 

[MadOgre]

X2 on that!

 

[Nicklepage1010]

If I'm going to be here I might as well contribute, I'll help you guys out if I can

 

[MadOgre]

Awesome attitude! were grateful to have you on here