Search results

  1. Danderson

    High Oil Pressure and Leaking After Oil Change

    That was my first thought also, but I changed the oil and filter again and this time went with a WIX filter. It didn't help. I have exactly the same symptoms even after changing the filter for a second time.
  2. Danderson

    High Oil Pressure and Leaking After Oil Change

    I've got an issue that has me stumped. I have a 1977 K10 that has a 350 Goodwrench crate motor installed by a previous owner so mileage is unknown. It's my daily driver and runs great. It has had a rear main seal weep for a while, but nothing more than a few drops overnight so I've put off...
  3. Danderson

    Well, Here We Go!!

    Welcome from the great state of Georgia! BTW, I've seen those factory bed rails go for about what you paid for the whole truck. Don't throw them out!!
  4. Danderson

    Help finding a part, new or used

    I wish you good luck......I've been looking for one on and off for over two years without success.
  5. Danderson

    Chrome ring around the Rim

    If I recall correctly, the 3" rings have a hole where the valve stem goes through and the metal completely wraps around the stem. The 2.5 " rings have a half-circle cut out on the inner lip for valve stem clearance, but the metal doesn't completely encircle the stem. It's been a year or two (or...
  6. Danderson

    Retrosound Hermosa or Custom Autosound?

    I put a Retro Sound Hermosa in my 77 K10 about a year and a half ago. Getting the two shafts set up just right was a bit of a pain, but I'm very OCD about my truck so I probably spent way more time on it than I should have. Looks good, works good, sounds good. I'm happy with it.
  7. Danderson

    One legged no more.

    That's an awful cheap price for a Yukon Grizzly locker. You got a great deal!!
  8. Danderson

    Introduction

    Welcome from Georgia. Where you at in Arkansas? I was born and raised in Conway.
  9. Danderson

    New guy from Ga.

    Welcome from a fellow GA resident!
  10. Danderson

    1977 K5 3000$ OBO!!

    I'm only two hours away and have been looking for a decent K5 project so I both emailed and texted the the individual early yesterday morning. If the owner would respond, I'd run right over and buy it. So far no response at all...........
  11. Danderson

    Part Identification...Please

    Looks like the neutral safety switch. It mounts to the top side of the steering column near the firewall.
  12. Danderson

    What have you done to your square lately??

    Spent way too much time this afternoon chasing down an electrical gremlin. I was driving along and the radio suddenly went dead. Checked the fuse block and found a blown fuse, so I replaced it and all was well.......for about ten miles and the radio went dead again. Same fuse blown. The radio...
  13. Danderson

    Classic Parts Repro Steering Wheel

    The tach markings go from 0 to 50 in increments of 5. The markings are x 100 RPM so the "5" marking is 500 RPM and the "50" marking is 5000 RPM. The truck idles at 700 RPM so the lower markings are very useful. The factory tach on my 2011 Silverado goes from zero to 6 with hash marks in between...
  14. Danderson

    What have you done to your square lately??

    Put a new sew-on leather wrap on my steering wheel. Came out great and I really like how it "thickens up" the feel of the wheel.
  15. Danderson

    Delay Wiper Module

    I could be mistaken, but I'm pretty sure the wiper park positioning is a function of the wiper motor and not the module. I also don't believe the windshield washer is controlled at all by the module other than direct power pass through.
  16. Danderson

    Delay Wiper Module

    They are near impossible to find. I swapped the delayed wiper system from a 1978 into my 1977 K10. It was a fairly straight forward swap until it came time to source the delay module. After much searching, I finally found a NOS module on ebay, but I had to pay $175.00 for it!
  17. Danderson

    Squarebody Down! HELP - Member Roadside Assistance Volunteer Map

    I'm near Chatsworth GA 30705
  18. Danderson

    Mystery wire

    Yep, safe to remove.
  19. Danderson

    Quadrajet Part Question

    Can't see your pictures!
  20. Danderson

    Mystery wire

    Is the wire spring loaded inside the white plastic piece? Looks like one end of an in-line fuse holder. Probably went to your no longer present eight track.
  21. Danderson

    Classic Parts Repro Steering Wheel

    I just bought the same wheel and installed it in my 77 K10 to replace the gummed up original. I agree that it is a very high quality piece. I'm extremely happy with it.
  22. Danderson

    truck is not sitting level - need help diagnosing

    Have you measured from the ground to the bottom of the frame rail on each side, both front and back?
  23. Danderson

    Hood sale price?

    "Old School" at 37?? You're still a kid! I was 30 when your truck rolled off the assembly line!
  24. Danderson

    79 K-10 in Alaska

    Hello from Georgia. Beautiful truck! looks a lot like my 1977 K10.
  25. Danderson

    Any help is appreciated...

    I had a very similar issue with my 1977 K10. Sounds like you have an intermittent loose connection somewhere in the ignition circuit. I was able to find my problem by starting at the distributor and wiggling the +12 volt connections and wires at each juncture in the circuit with the truck...

Latest posts

Forum statistics

Threads
45,453
Posts
983,774
Members
38,501
Latest member
thatgermanguy
Top