Search results
-
81-87 manual carpet for sale.
I have a 84 GMC C 15 auto trans. Bought carpet and they sent me the manual “high hump” trans tunnel carpet. Does not fit. I did not get to a point where I was ready to put it in until this weekend. That’s when I discovered it was wrong. Looking to sell it. Brand new, no cuts, holes just straighg... -
-
3” drop spindles on 1984 c15
I have a 1984 c15 short bed. Had brakes put on new. I went off the box they came in brakebest select 5006rgs. Comes up as 1.25 disks. So I ordered 3” drop spindles for that. I went and measured them and they are 1”. Can I still keep the new brakes and use the spindles or should I just send them...- duece1951
- Thread
- Replies: 2
- Forum: Introduction
-
A whole forum just for GM Squares?
Welcome from Florida! This is a great site and very friendly with ideas and answers. Best part is you figure out your not the only one having the same issue- duece1951
- Post #17
- Forum: Introduction
-
A whole forum just for GM Squares?
- duece1951
- Post #16
- Forum: Introduction
-
-
Hi everyone!
Not only that but most of the emissions are cut out or removed. Lucky to get 10mpg at this point!- duece1951
- Post #16
- Forum: Introduction
-
-
Under dash air box hvac.
My dash vet door only closes to about an inch and a half. Can hear a vacuum leak from the back. That why I asked if there was an east way. Not sure if that it but the entire dash is apart so need to address it now instead of doing this twice.- duece1951
- Post #4
- Forum: Gate Keeper Products
-
Hi everyone!
Just a start. Apparently only 5 pictures at a time- duece1951
- Post #5
- Forum: Introduction
-
Under dash air box hvac.
So I need to remove the entire box to get at it well. I have all the other vent plumbing out to see them move and clean it in case there was stuff in there. Hornets nest and glass. Could something be bent inside?- duece1951
- Post #3
- Forum: Gate Keeper Products
-
Hi everyone!
First squarebody. Went on vacation with my wife this summer and bought a truck on the side of the road on GA had it shipped home to Florida. Runs and drives! Done a lot so far mechanically. Like big frustrating Lego project!- duece1951
- Thread
- Replies: 15
- Forum: Introduction
-
Oil pressure switch and sensor HELP!!
Also when I test the contacts in the dash the gauge goes into I get no power period.- duece1951
- Post #2
- Forum: Introduction
-
Oil pressure switch and sensor HELP!!
Why does my 1984 c15 have a oil pressure switch and and oil pressure sending unit? The one down by the oil filter is hooked up and the one behind the distributor is not hooked up, broken wire. Can’t find the tan wire that it came detached from. Oil pressure gauge reads 60 psi in the truck or...- duece1951
- Thread
- Replies: 3
- Forum: Introduction
-
Shift Position Indicator
Yes you can adjust the indicator with the clip. As long as it does not bend when you take it off you can reuse it. LMC was the least expensive that I found for a new one. Just replaced mine last week, the orange needle was snapped in half. -
Under dash air box hvac.
Hi everyone! New here. I bought a project truck, 1984 GMC short bed with air conditioning. Sat in a barn for 10 plus years. Runs and drives. I have vacuum to the system but the vacuum does not close the dash vent door completely. Last night I noticed an air leak sound seemingly from behind the...- duece1951
- Thread
- Replies: 5
- Forum: Gate Keeper Products
