TH350 oil level, engine off

WFarm · 2025-04-20T15:54:06-0400

I am planning to install a temperature sending unit in my TH350 and was leaning towards installing the unit in the 1/8” NPT pressure tap port, circled in yellow. With the engine off and tranny cold is this port above the fluid level ( assuming not overfilled) or will I need to drain fluid before removing the plug?

You must be registered for see images attach

Matt69olds · 2025-04-20T21:07:07-0400

Installing a temp gauge in the case is useless, there is no fluid flow. All you will read is the temperature of the transmission case.

Put the sending unit in the pan.

hey mister · 2025-04-20T21:41:08-0400

Ditto.

Replacement oil pans are made with ports for temp probes.

ali_c20 · 2025-04-21T01:37:27-0400

You can install the sender in the outgoing cooler line if you don't want to pull and drill the pan. There is a lot of debate where to put the sending unit, don't want to jump into that rabbit hole. You just need a fitting/ manifold to mount the sending unit.

https://www.glowshiftdirect.com/5-16-transmission-line-t-fitting-adapter/

https://www.summitracing.com/search/part-type/temperature-sender-manifolds

bucket · 2025-04-21T08:16:59-0400

Matt69olds said:
Installing a temp gauge in the case is useless, there is no fluid flow. All you will read is the temperature of the transmission case.

Put the sending unit in the pan.

I have to disagree here. While the test port may be a dead end, there is still flow of fluid with the trans in operation. Unless the th350 is somehow much different than a 700r4.

TH350 oil level, engine off

WFarm

Full Access Member

Matt69olds

Full Access Member

hey mister

Full Access Member

ali_c20

Full Access Member

bucket

Super Moderator

Similar threads

Latest posts

Forum statistics