wildgoose's latest activity
-
You shouldn't need to pull out seats. It will run down the side by the driver's door. Usually taking the plastic piece off the lower... -
White wire is ground- both sides should have one. Tan wire is for key left in ign ground (warning ding) - only on driver side.
-
wildgoose replied to the thread Let’s slay this dragon….Thanks. The white wire from that orange/white pair does in fact run behind the fuse box to above. I can’t see where it goes but assume...
-
Orange wire is taking power to dome light. White wire is ground coming back- it is spliced somewhere slightly above the fuse box with...
-
wildgoose replied to the thread Let’s slay this dragon….Should both door switches have 2 wires connected to the switch? Driver side had 2 but passenger side only 1.
-
Dome light has power standing one side of bulb, switches ground. Likely a broken wire under carpet drivers side.
-
wildgoose replied to the thread Let’s slay this dragon….Thanks!! Yeah that one is probably the first one I’m going to trace. Also concerned about the fuses that a lower amp rating than what...
-
Looks like spaghetti has replaced the traditional turkey meal? You can get a wiring schematic from LMC for cheap. It's worth it.
-
Any wire with a crimp on connector is not factory, such as the yellow wire near the flasher. Not saying that is all bad just trace it...
-
wildgoose replied to the thread Let’s slay this dragon….I get it… there will always be a tracing job. No doubt I’ll have to track down where a lot of these go. But being new to these trucks...
-
wildgoose replied to the thread Let’s slay this dragon….Is it just the same schematic in the wiring manual printed out?
-
Okay for the guys doing gas swaps into diesels. Use the injection pump solenoid wire to control the ignition. Disregard/delete the glow...
-
Hate to state the obvious, but you will probably just have to start tracing wires to.see where they go. You will probably find one of...
-
wildgoose replied to the thread Let’s slay this dragon….Snipped a zip tie and was able to make some progress in removing a few wires that weren’t terminated on either end so figured nothing...
-
-
wildgoose replied to the thread Let’s slay this dragon….I don’t disagree with that! Thanks Hut! You too.
