Recent content by WFO
-
-
-
Introduction and BBC to SBC???
Welcome from up in the Panhandle. That's a good lookin truck.- WFO
- Post #8
- Forum: Introduction
-
-
What would you pay for this truck?
I remember when they were new, they were the cheapest.- WFO
- Post #44
- Forum: Tech Discussion
-
-
New memeber old mechanic 73 chevy 350
Welcome from the Texas Panhandle.- WFO
- Post #6
- Forum: Introduction
-
NOG Here
Welcome from the Texas Panhandle. I see your location is earth. Probably not Earth, Texas is it?- WFO
- Post #13
- Forum: Introduction
-
Hello new
Welcome from the Texas Panhandle, Ma'am. And thank you for your service.- WFO
- Post #11
- Forum: Introduction
-
Finally got a running 65 C10
With the piston down, I had a buddy hold the valve up with the handle end of a screwdriver through the intake port while I compressed the spring.- WFO
- Post #157
- Forum: Other Vehicles
-
New here , clutch slave master cylinder help.
I pull the slave cylinder off and hold it with the hose end up. Then I push the piston rod in and release it several times until bubbles quit coming up in the master cylinder. You need someone watching the MC to watch the bubbles, and to make sure the fluid level doesn't drop too low.- WFO
- Post #9
- Forum: Introduction
-
Hello new member from central North Carolina
Welcome from the Texas Panhandle.- WFO
- Post #6
- Forum: Introduction
-
-
Huck's daily - 2005 Z71 crewcab
I'd imagine that machine shop can get'er done.- WFO
- Post #302
- Forum: Other Vehicles
-
Huck's daily - 2005 Z71 crewcab
I think I'd gamble a few bucks on a left handed drill bit, hoping it might grab hold and spin it out. A few years ago, I bought some CRC Freeze-Off to loosen bolts. Best investment I've made in a while. Not because it works, but because I haven't needed it yet. I figured if you heated the...- WFO
- Post #298
- Forum: Other Vehicles
