WFO's latest activity
-
I was also wanting a plain black style. I didn’t want to flush the money and time I spent on this bezel/gauge install so I improvised... -
Thank you. It is an older Clifford 4 barrel manifold, Aussie cast Dutra Dual split manifolds, Quick fuel 450 carburetor, JP performance...
-
In my Dart, 71 225/auto
-
Axle seal install rig for my Dodge Dana 60 front Axle tube scraper
-
WFO reacted to Ryanbrown36's post in the thread Holley street warrior 600cfm for sbc 355? with
Like.
I ended up buying the carb anyway due to the steal of a price I got it for, so will see how it preforms, worst case I can sell it for at... -
WFO reacted to Grit dog's post in the thread First real drive! Not tragic but not good. I think I need carb advice. with Like.
You can always diagnose the fuel pump output vs any blockage from the tank by connecting the pump inlet to a hose in a gas can and see...
-
I would normally recommend Powermaster, however, the last one I bought already had an audible bearing noise at idle, and still does. But...
-
https://bringatrailer.com/listing/1987-chevrolet-r10-pickup-20/
-
Replaced the grille, BowTie and 454 emblems. Grill was broken in a couple of places. New grille fit fine but was a bit disappointed that...
-
WFO reacted to bucket's post in the thread Changing gear ratios: opinions/suggestions wanted!! with Like.
@Ricko1966 is a very serious person. He only jokes about buttered toast, knitting and cat's asses :rofl:
-
Most likely float level is too high,maybe float is heavy,. Carbureator looks new my 1st guess is not put together correctly from the...
-
Nice, thanks @quicksilver702. Reach out to me off-line if you run into any problems with the build...Since we are in the same city (I'm...
-
Ya gonna put a Blower on it? I had a Sanger Flat bottom drag boat I built a couple BBC motors for
