vr1967's latest activity
-
Vvr1967 reacted to RattleSnack's post in the thread Corp 14 bolt brake line difference question with
Like.
Yep....ditto that. Also, the spring perch widths are different from 3/4 ton to 1 ton. The spring perch width (center to center) on... -
Vvr1967 replied to the thread Corp 14 bolt brake line difference question.The bottom rear is from a 1 ton, as you can tell by the shock bracket placement. (In front of axle on passenger side on 3/4t, behind...
-
Vvr1967 replied to the thread Finally got a running 65 C10.Nice looking old 65. Kind of partial to them, as still have the old 65 my grandfather bought new here in the little town I live in...
-
-
VMoar
-
VAnd some more
-
VHere’s a few more
-
VFinally! I could afford a running driving 60s pick up. I sold my 2022 Honda CB 1000 R to get this. Went from doing 160 miles an hour on...
-
Vvr1967 replied to the thread Definitive interchangeable parts thread 73-87(91) (non-drivetrain).Those old 208s held up better than most folks think. From privates to NCOs, they were well tested for strength. Also had a better gear...
-
Vvr1967 replied to the thread Definitive interchangeable parts thread 73-87(91) (non-drivetrain).The M1008 CUCVs (we called them “Cuck Vs”) were listed as 1-1/4 ton, and had NP208 (chain driven) transfer cases. But the CUCVs were not...
-
Vvr1967 replied to the thread Another leaf spring question: (plastic shims)..Shop around by pn I used the pn D-58 from KC Spring (not sure d-58 is what you need, just used it as an example)...
-
Vvr1967 reacted to Grit dog's post in the thread Precision windshield gasket, self locking or lock strip? with Like.
Maybe I got lucky. First and only square body windshield. Successful install. No sealant used, no leaks, no broken glass. Although me...
-
Vvr1967 replied to the thread Early 4.3 upgrade?.While not really relevant to the original post, Some of the later engine changes (post 98) included elimination of the egr valve and...
-
Vvr1967 replied to the thread Windshield Antenna.I may still have one or two. Will try to remember to look tonight when I get home.
-
Vvr1967 replied to the thread Shifter Knob.I have one, just got to put my hands on it again. Did take a picture of it then as I had planned to list it.
-
-
Vvr1967 replied to the thread SM465 locking between gears.Pull the shift lever and check for slop in the pins. (Circled below) slop in them will cause shifting problems.
-
