Recent content by Truck82
-
Did GM use Spicer parts from the factory?
Ok, yeah mine are 30 spline. Thanks for all the information. It helps to have someone who understands there’s people like me that know nothing about some things and just need a little help :cool:- Truck82
- Post #10
- Forum: Differential & Driveline
-
Did GM use Spicer parts from the factory?
It must have been rebuilt in the past then. It’s got Moog ball joints and what looks to be brand new Timken bearings(there was brand new grease too) If I’m not mistaken, the GM 10 bolt came with two different axle shaft inner gear spline count? Is one better than the other?- Truck82
- Post #8
- Forum: Differential & Driveline
-
Did GM use Spicer parts from the factory?
It’s a 1991 3/4 ton suburban, 4x4 Edit: Are Moog parts stock?- Truck82
- Post #6
- Forum: Differential & Driveline
-
Did GM use Spicer parts from the factory?
@Bextreme04 @nvrenuf Thanks for the information. The truck had a lift and some other aftermarket stuff so I wasn’t sure what was stock on the axle- Truck82
- Post #4
- Forum: Differential & Driveline
-
Did GM use Spicer parts from the factory?
As the title asks, did GM use Spicer axle shafts on the 10 bolt front end from the factory or is that aftermarket only? If anyone knows anything about it, it would be greatly appreciated. I couldn’t fine anything on the internet. Thank you all in advance!- Truck82
- Thread
- Replies: 10
- Forum: Differential & Driveline
-
Response to “Caution Please Read” post
Welcome from Washington!- Truck82
- Post #12
- Forum: Introduction
-
POR 15 equivalents?
That cost a lot of time and money but, dang, that looks great in the end! -
POR 15 equivalents?
Yeah, I’ve heard the down side to POR 15 is you really have to make sure it’s CLEAN. They’ve got so many products for cleaning that it gets expensive to do it “the right way”. This Mastercoat looks to be some tough stuff! -
POR 15 equivalents?
Paint peals and surface rust happens pretty fast but nothing serious. It’s very wet in western Washington. -
POR 15 equivalents?
And this is with a spray can or brush on? That looks really good, actually. That’s held up real nice especially for where it’s at. Those wheel tubs get abused pretty good -
POR 15 equivalents?
I know a lot of people use KBS for tanks with good results. Aim thinking about going with them because it’s fairly cheap on the jungle store -
POR 15 equivalents?
I’ve never heard of that one before. I’ll check it out. Axles, springs, and other suspension parts. -
POR 15 equivalents?
Yep, looks like they do. It’s about $30 cheaper too! -
POR 15 equivalents?
Hey everyone, Just wondering if anyone knows of a good equivalent to POR 15 black paint that is a little cheaper. There’s a few out there that I’ve found but I want some insight from people that have actually used them. Thanks everyone! -
How much are these parts worth?
I wouldn’t scrap it. I don’t see how I would ever scrap something that still works or could be fixed. Unfortunately I’m not in the position to store a lot of bigger things like this or I would hang onto it. I’ll post it up and see what happens.- Truck82
- Post #12
- Forum: Suspension, Steering & Brakes
