TotalyHucked's latest activity
-
to rule that out we put it in 4 wheel drive but sound didn’t change and in 2 we ziptied both axle shafts at the u joint to make sure... -
TotalyHucked replied to the thread LS regasket question.Here's what I mean by holding the straight edge at an angle, you wanna get as much on the pan itself and the out to the ears of the...
-
-
TotalyHucked replied to the thread Door Hinge Shims.I'd actually never decoded the VIN till just now. It was built right here at Lakewood
-
I’m curious, what plant was the gold truck built at?
-
TotalyHucked replied to the thread Body repair panels.Hey Robert, I work for AMD so I can shed some light. Generally, the "premium" panels were developed in recent years and feature newer...
-
AMD would be my go to for quality parts. They are on this forum and willing to help. Eric
-
TotalyHucked replied to the thread Door Hinge Shims.Also, just be aware you're only going to get the A-pillar gap so good. They were junk from the factory and varied WILDLY. Here's my blue...
-
-
A few things: So you currently don't have a rocker panel installed? If there is also not a full inner rocker or floor pan, your A and B...
-
TotalyHucked replied to the thread LS regasket question.Then the last step is checking the alignment of the back of the pan to the back of the block. I used the same 12" straight edge for this...
-
-
TotalyHucked replied to the thread LS regasket question.I JUST did this on my daily's 5.3 (2005 LM7, same thing). I've done them in the past but I bought a book about rebuilding an LS because...
-
-
TotalyHucked replied to the thread Hood Adjustment - Front Needs to go Down.Nice! Glad you got that figured out
-
TotalyHucked reacted to Russtypickle's post in the thread Hood Adjustment - Front Needs to go Down with
Like.
Ok, I've got photos and I removed the front springs (thanks for that suggestion TotalyHucked). That didn't really change much but it did... -
There shouldn't be shims there, but it's a quick way of adjusting the door with the fender still mounted. As for causing stress cracks...
-
TotalyHucked reacted to Sammy's post in the thread Issue resolved - New parts on the way -- Key will not insert into the ignition switch with Like.
Thanks for all the suggestions and information. I did see a broken tumbler inside, I couldn't get it out. Ordered a bunch of stuff from...
-
TotalyHucked replied to the thread Auto wiper lifters to save edge.Lol what? You know you can take the arms off and adjust them up 1 spline or so to keep them off the gasket, right?
