Ricko1966's latest activity
-
RTo wire your Sony XM-N1002 (2-channel, 1000W amp) to two 12" subwoofers, we need to consider: Subwoofer impedance (ohms) – Are your...
-
RRicko1966 replied to the thread Frost bite radiator & electric fan???.Not to nit pick but your truck is not being restored if it's got a 3 inch lift kit,not saying it's not cool, just not restored. Another...
-
RRicko1966 replied to the thread Frost bite radiator & electric fan???.I'd try lowering and triming the shroud and running a 6.0 fan. Lots of cases where going back with a mechanical fan fixed overheating...
-
-
RYeah the factory charcoal canister is pretty slick. There is a thread on here on what each connection is for here. The short of it is...
-
RRicko1966 replied to the thread Frost bite radiator & electric fan???.A 6.0 fan
-
RRicko1966 replied to the thread Frost bite radiator & electric fan???.Most electric fans cannot move as much air as an engine driven fan,most aren't even close. If an electric fan is against the radiator no...
-
-
RRicko1966 replied to the thread Wiring Two subs together?.That looks to me like you are trying to run two speakers in parallel which would make the load 1/2 of what the speakers are labeled as...
-
RIt all depends on the block. There were certain 283s that could go an 1/8.........but NOT many that would last. I do think I have one...
-
RYes we used to bore them .125 over in the early 80s and called them 301s not realizing that made a 4 inch bore and basically a 302 like...
-
RWeren't there guys that bored them like .120 over or thereabouts?
-
RA complete running 5.3 and trans for 1500 is way cheaper than most areas, or at least the areas I've been in. But even with that, I'm...
-
RThat's not it at all. In your first post, you talked about the best bang for your buck to make it reliable. Anyone that has done or seen...
-
RRicko1966 replied to the thread What new tools have you got lately?.Pipe and tubing are measured differently so you need to modify the dies to fit tubing. And then .pack with sand and make a clamp for the...
-
-
RI've been told that you can pack the tube with wet sand and you're less likely to crush it at the bend. But WTF do I know. Never tried it.
-
RRicko1966 replied to the thread Early 4.3 upgrade?.Go 455 olds,good engines tons of torque and it's a bolt in using 5.7 diesel mounts.
