Ricko1966's latest activity
-
RThere’s a few circuits in the cab hot while cranking, under the hood I think the coil wire should be hot on run and start. Get your test...
-
Rhere is a wiring diagram: https://www.mediafire.com/download/9ih3gy2t94wadpt/X8430_1984_GMC_CK_Light_Duty_Trucks_Wiring_Manual.pdf I...
-
RIt sounds like you have the return lines swapped on the valve or the valve is not switching properly. Make sure that the feed and return...
-
RI use the 20v Dewalt stuff, as do most of my coworkers. I've seen a lot of it get abused and it holds up well. This past summer, I...
-
RThis is a pretty good description of what should be happening, but I'll add a few caveats. Early quadrajets like this one only had one...
-
RHas multiple issues. Check for spark and plug condition. On that style carb choke thermostat is heated by the intake. There should be...
-
RRicko1966 replied to the thread Rochester Quadrajet Woes.Get it running again first. Then deal with the carb after you've sorted out the other issues. Reason is you change x y and z at the same...
-
RWhens the last time its gotten plugs wires and a coil? Failing to run on ether is the red flag, its not a carb issue i dont believe
-
RI'm thinking it should at least fire on ether regardless of carb issues. Have you checked for spark at the plugs?
-
RThe Mcbay website will answer all your questions. They have spacers for 1 7/8 to 2 1/4" lift in stock.
-
RMcbayperformance.com, I used their coil spring spacers to lift my truck and am happy with the result. Easy to install, several options...
-
RRicko1966 replied to the thread Rebuild th400 or 4l80e?.You're right, you would have to shift with switches or by manually moving your shift lever.
-
RRicko1966 replied to the thread Coil spring lift spacer questions.Check with mcbay or one of the manufacturers. It may be that you use 1 inch spacers for 2 inch lift. You could measure the difference of...
-
RRicko1966 replied to the thread Coil spring lift spacer questions.My opinion 2 inches you'll be fine.A 2inch steel spacer under the spring,set the camber and toe. Let er rip. You can set camber and toe...
-
RRicko1966 replied to the thread Rebuild th400 or 4l80e?.You do not have to have a computer to go 4l80. It takes mods to put on vacuum modulator,and a little wiring.
