Ricko1966's latest activity
-
RRicko1966 reacted to Bextreme04's post in the thread Big block running hot. Can’t figure out the issue with
Like.
oof... bummer. Glad you checked it though. If you had it dialed in near sea level and are now in Denver, I would start by dropping 2 jet... -
RRicko1966 replied to the thread 4.8/5.3 to 383.You could bore a 6.0 block and run a 3.75 crank. That would get you a 383,you could run a stock 6.0 block and and 3.81stroke,you could...
-
REverytime I see this I want to scream! Grounds are not rocket science or difficult, if your component doesn't come on and you verified...
-
RRicko1966 replied to the thread ignition coils.To check engine ground put 1 lead of your volt meter on the negative battery post,put the other lead on the block. With the engine...
-
RIs the motor grounded good? There should be a ground from battery to motor. The distributor grounds to the motor. You mentioned...
-
RRicko1966 reacted to 77Dmax's post in the thread Jet Performance Quadrajet JET Performance anyone gotz? with Like.
-
RRicko1966 reacted to nvrenuf's post in the thread Jet Performance Quadrajet JET Performance anyone gotz? with Like.
I’m no real help but I thought I’d post that my qjet was built by Sean Murphy Induction which was supposed to be a group of former Jet...
-
RRicko1966 replied to the thread 04 LM7 into 87 K5.Hot key in crank position,use the starter solenoid exciter wire.
-
RRicko1966 replied to the thread Help identify strange noise at Highway speed.What are the chances you changed engine mounts? Poly or steel mounts will make noises much more noticeable.
-
RRicko1966 replied to the thread Rear drum spring kit.I believe you are holding the rear brake hold down spring seats.
-
RRicko1966 replied to the thread Heavy vibration at highway speed under load.The rear diff slop is probably NBD if you fix it now or soon. It will be a big deal when it starts making noise. Pinion...
-
RRicko1966 reacted to JD Miller's post in the thread Jet Performance Quadrajet JET Performance anyone gotz? with Like.
You are completely Wrong :thumbsdown:
-
RRicko1966 replied to the thread brake pedal has no pressure.Both of these will cause a high hard pedal.
-
RRicko1966 replied to the thread Need help identifying this metal line coming out the back of my carburetor.Let's leave the trannys out of this.
