Ricko1966's latest activity
-
RMy weak link right now if I go with 1410 u-joints is the locking hubs on the front axle. They are MM 35 spline Dana 70 hubs. If I have...
-
RWelp, that went sideways. Hope you get it fixed. You say non productive, when you got solid advice. I'm out.
-
RRicko1966 replied to the thread Weird Headlight Problem.Well the headlights don't have a fuse or go through the fuse panel. The headlight switch wont just power some headlights but not others...
-
RRicko1966 replied to the thread Thread sealant on header bolts?.I can tell you for 99.99999 percent positive that you aren't leaking oil from the exhaust bolts them selves the only oil in a SBC head...
-
RRicko1966 replied to the thread 255/60/15 vs 275/60/15.I'd run the 255s on all four corners 2nd choice would be the 275s on all four corners,reason being you can rotate them,a spare would be...
-
RRicko1966 replied to the thread First real drive! Not tragic but not good. I think I need carb advice..We need a pic with the air cleaner off. Need to see where the stray hose connects to the carbureator. In your second Pic that is the can...
-
RRicko1966 reacted to fast 99's post in the thread First real drive! Not tragic but not good. I think I need carb advice. with
Like.
A couple pictures would help. Obviously with headers the heat riser valve is gone. That effects intake preheat and choke operation. Hard... -
RBasically, there's two common setups. The original aftermarket type roller cam for use in all small blocks requires a cam button to...
-
RRicko1966 replied to the thread Thread sealant on header bolts?.Wipe the area between the breather and the oil spot with a rag. I'll bet oil is venting from the breather and running down.
-
RRicko1966 replied to the thread Big block running hot. Can’t figure out the issue.I'd hope you'd have some heater hose laying around,cut hole in the bottom of a 2 liter bottle,remove your heater hoses hang the bottle...
-
RThe passenger side valve cover should have two holes in it. The one nearest the firewall is for the crankcase breather tube going into...
-
RTo be more specific, that is only chlorinated brake cleaner. The PERC that is contained in the chlorinated cleaners is a major...
-
RRicko1966 replied to the thread Thread sealant on header bolts?.On cheap chromes I've never had luck unless I take the right angle die grinder th the sealing surface on the valve cover to rough it up...
-
RMy 6.2 does not like the cold but it sure likes the factory block heater. I have it on a timer. The quicker you can get the engine up to...
-
RCheck your wiring, too, against a wiring diagram. When I installed an LMC headlight relay harness, their pinouts on the headlight...
