Ricko1966's latest activity
-
RRicko1966 reacted to fast 99's post in the thread 1973 k20 350 intermittent bogging under load with
Like.
Check fuel pressure and volume. Quite a few bad pumps out there. -
RRicko1966 replied to the thread Bondo roof. What to do?.Unispotter...
-
RRicko1966 replied to the thread Front end noise.If the play is in the pinion bearings you'll have to replace the pinion bearings
-
RRicko1966 replied to the thread Front end noise.Push up and down on the front pinion yoke,looking for a sloppy pinion bearing.
-
RI put the wheel bearings in back in May and didn't have any weird noises until a couple weeks ago
-
RRicko1966 replied to the thread Front end noise.How new are the wheel bearings? I have a noise in the front end,and I have new front wheel bearings in the same post,puts a red flag on...
-
RDoes it have a TPS connector? Pictures are easy to post.
-
ROne thing to note is the 833 used in square bodies is the overdrive variant, with a 3.09 first. The old Mopars pre 1975 are a direct...
-
RIf its the same as a chrysler a833,it will take whatever you can throw at it.
-
RRicko1966 replied to the thread ‘87 454 R20 eye watering exhaust w/ windows down.If your tailpipe exit straight back,the turbulence of air over and under the car push the exhaust fumes in through the open back window...
-
RIIRC, .060 plug gap was an early spec for HEI, maybe when they were trying to improve the burn for emissions. Later on they found it...
-
RThere is definitely a difference between Delco Modules and all others. A Delco will always saturate a Delco coil correctly. It will...
-
RRicko1966 replied to the thread Spark plug foul up.So third time asking,does your timing advance?
-
RAll TBI and Vortec distributors in the GMT-400's are .427". That gear PN i gave you is for a stock .427 shaft Vortec distributor. Here's...
-
RFactory 97-up 7.4L distributor gear is the answer here. I put one on my 97 K2500 454 when I rebuilt everything. It's a factory AC Delco...
