Ricko1966's latest activity
-
RRicko1966 replied to the thread 88 suburban 350 rebuild questions..Yes I'm sure that was part of the reason they ground the crank that way. By running cylinder head to piston clearance of .040 you get...
-
R^^^^ This is a great option on a budget. I re-ringed and put bearings in the 350 that came out of my moms ‘83 K5, it probably had...
-
RGet some pictures of the transmission, adapter and transfer case. We can then help determine what you have currently and what your...
-
RRicko1966 reacted to Nasty-LSX's post in the thread Help me solve a cooling issue. Pic's inside. with
Like.
My block and water pump do have the extra hole as you shown in the pic. Thanks for post so that for other to see. :cheers: I have a... -
RRicko1966 replied to the thread Rebuild or Swap?.If all you have is blowby, you may be able to get by with a simple rering and bearings,upgrade the cam and heads. Depends on your budget...
-
RRicko1966 replied to the thread Bowler Clutch pedal?.Post 6 I put a link to bluex write up on the wildwood to manual pedals. As for swapping pedals to your bracket, I couldn't tell you for...
-
RRicko1966 replied to the thread Don’t know what to do about shocks.Oh crap, my bad I was looking at C's I'm going to start over. Sorry k front and rears stock and lifted. Not recommending these just...
-
-
RRicko1966 replied to the thread Don’t know what to do about shocks.How are you measuring the length of the shocks? Put a jack under the frame jack the truck up until 1 wheel is hanging. What's the...
-
RRicko1966 replied to the thread Don’t know what to do about shocks.I haven't seen how your determining correct length. This is determined by finding fully extended length and fully compressed length and...
-
-
RRicko1966 reacted to gmbellew's post in the thread Engine died when driving and won't start - Coil melted with Like.
spare parts I carry- bulbs, radiator hoses, ICM, external coil, couple old plug wires swapped every 30k miles, timing light, cap/rotor...
-
RRicko1966 replied to the thread 1987 R10 shutoff while driving.NAPA and GM modules were and probably still are the only modules that vary dwell time. As @gmbellew said use a GM module or good NAPA...
-
RRicko1966 reacted to AuroraGirl's post in the thread tranny mount/crossmember- urgent help needed with Like.
305s made gm money people paid to not have them, and they increased CAFE when that became a factor, because if you didnt give them money...
-
RRicko1966 replied to the thread tranny mount/crossmember- urgent help needed.CAFE stood for corporate average fuel economy, people tend to forget about this.The trucks had to average x mpg across the line. So...
-
RRicko1966 reacted to bucket's post in the thread tranny mount/crossmember- urgent help needed with Like.
It doesn't matter if the spacers are on top or below, as long as they aren't between the frame and the crossmember.
