Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
Registered members
Current visitors
Menu
Log in
Register
Install the app
Install
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
RanchWelder's latest activity
RanchWelder
replied to the thread
87' Blazer Short Bed 3/4 Ton 5th Wheel Conversion.
.
Cheap stuff in the tank we had.
Aug 26, 2024
RanchWelder
replied to the thread
Multiple Battery types and the danger of diode damage with modern batteries mixed with Lead Acid and OEM alternators.
.
I'm good.
Aug 25, 2024
RanchWelder
replied to the thread
87' Blazer Short Bed 3/4 Ton 5th Wheel Conversion.
.
Here's the 60 inch springs and 14-Bolt rear axle installed. New to me Locker 10.5 inch Full Floater, custom drive shaft. Pulled the...
Aug 24, 2024
RanchWelder
posted the thread
87' Blazer Short Bed 3/4 Ton 5th Wheel Conversion.
in
Tech Discussion
.
Here's the Demco getting nstalled to the Blazer bed: Side Plates for the Frame: (Spot welds have not been hit with a grinder yet...
Aug 24, 2024
RanchWelder
replied to the thread
Multiple Battery types and the danger of diode damage with modern batteries mixed with Lead Acid and OEM alternators.
.
Moving.
Aug 24, 2024
RanchWelder
replied to the thread
Np208 yoke
.
Bump...
Aug 24, 2024
RanchWelder
replied to the thread
Np208 yoke
.
No big deal. It's fixed. Do you have any experiance with transmission work? I'm stuck without reverse on 4L80E rebuild. The New Sonnax...
Aug 23, 2024
RanchWelder
replied to the thread
Np208 yoke
.
I thought I private emailed you... wait I did? Thought you responded to me private through email. Had no idea you started a new thread...
Aug 23, 2024
RanchWelder
posted the thread
5th Wheel RV in MT for living quarters.
in
Wanted
.
Hey Mountain men and ladies! Hello to the Rolling Hills and Parie dwellers! Looking for a good clean older-ish RV for me and the Bat...
Aug 23, 2024
RanchWelder
replied to the thread
Np208 yoke
.
Must have ripped the seal for it to be leaking this bad during the rebuild. Might have to pull the yoke and try to replace the seal...
Aug 23, 2024
RanchWelder
replied to the thread
Np208 yoke
.
Pardon me, I scrolled down the page and found the entire list of years. Wow.
Aug 23, 2024
RanchWelder
replied to the thread
Np208 yoke
.
I agree with drive line length analysis. After dropping the 4L80E to 4-1/2 inches below the frame,over the standard case lowering pins...
Aug 23, 2024
RanchWelder
reacted to
PrairieDrifter's post
in the thread
Hydro Clutch Pedal Assembly...from an S10?
with
Haha
.
I don't envy that wiring in the slightest. Makes some of my trucks look fantastic when I got em!! compared to that :rofl:
Aug 23, 2024
RanchWelder
replied to the thread
Electrical dash wiring / wire color issues.
.
This information is incorrect. Running a 12 AWG from the tan/white stripe wire to the gray fuel pump power at the tank, killed my ECM...
Aug 12, 2024
RanchWelder
replied to the thread
4L80E fresh rebuild, no reverse.
.
Yah... No. Same issue, no pressure with connector unplugged. Should be 300+psi and instead it's 49 - 195 on the pedal, in reverse, foot...
Aug 12, 2024
Latest posts
Body to frame webbing??
Latest: Keith Seymore
3 minutes ago
Paint and Body
K
QJet Questions
Latest: Kilian
24 minutes ago
Carb Fuel Systems
Does a seal exist for my factory 1977 c10 sliding window
Latest: TotalyHucked
27 minutes ago
Glass & Mirrors
What have you done to your square lately??
Latest: TotalyHucked
31 minutes ago
Garage
Potential wiring problem
Latest: Jgonick
Today at 7:37 AM
Tech Discussion
Forum statistics
Threads
43,850
Posts
944,467
Members
35,876
Latest member
Maxw1987
Members
Top