peats's latest activity
-
Ppeats reacted to Ricko1966's post in the thread Instrument cluster questions on new build with
Like.
^^^^^^ senders have to match the year of the gauge cluster. And type of gauges. Meaning if you've got an oil pressure light you need an... -
PA blazer is not the choice for big lift and a street driver. It'll ride like crap. You'll be doing u joints every month lol
-
PWhy an 8 inch lift? That is an extreme amount of lift for a vehicle that won't be off roaded in a manner that warrants that much lift...
-
PJust my opinion…. Use an 83 K30 w/ 454 as the application to shop for parts. Get a factory 4 row radiator and matching shroud then a 7...
-
PSomeone spent an incredible amount of time and material on that. Too bad they won't recover what the paint cost. Question where people...
-
PWhen I was searching for new dash pads I ran across an article where someone took a metal core like that and put a dash overlay right on...
-
POr the TV geometry is incorrect or the cable adjusted incorrectly.
-
PThe "correct" gear ratio isn't determined my keeping the speedometer accurate. The correct gear ratio is determined by the desired mix...
-
PIf I were to stick with the V6, I'd start with a 4.3 from a '96+ truck. They have much better heads, a balance shaft and a factory...
-
PSeriously with all the people doing LS swaps you should be able to find a usable as is SBC cheaper than you can buy a stock rebuild...
-
PIf you can't get it to idle you can't set timing anyway, so put it where ever it runs best for now. If the rpms are too high the weights...
-
PVacuum gauge can tell a lot. Is the balancer new or used? Has TDC been confirmed? Pointer/mark adjusted if if was off? If you are...
-
PCheck vacuum and compression,as well check for vacuum leaks,use carb cleaner around the manifold base. Hook a vacuum gauge to the...
-
PThe GM engineers did it for a reason. Don't mess with it.
