peats's latest activity
-
PA $30 block heater has never done me wrong. Never replaced one either. Starts obviously way easier, gets heat in it wayyy faster. -20F...
-
PNow think about this. If you put a magnetic heater on the oil pan you will have 5 quarts if warm oil in the bottom of the pan. The block...
-
PNo leaks missing transmission fluid pull the line off at the vacuum modulator,if there's fluid in that line the mystery is solved.
-
PI've used Lexol with good results.
-
Ppeats reacted to TotalyHucked's post in the thread 1973 - 1987 Step Side fender splash aprons with
Like.
I get what you're saying but it's a non-issue unless you're in a 4wd that'll be offroad all the time. I've got close to 60k on my truck... -
Ppeats reacted to WebMonkey's post in the thread 1973 - 1987 Step Side fender splash aprons with Like.
'monkey is sad now AGAIN at least here, i'm not the person who built/designed/tested the subject matter for decades. when i try to...
-
Ppeats reacted to Grit dog's post in the thread 1973 - 1987 Step Side fender splash aprons with Like.
That said, how could you even consider putting yourself or your family at “risk” of being exposed to a traffic collision in such an...
-
Ppeats reacted to Grit dog's post in the thread 1973 - 1987 Step Side fender splash aprons with Like.
You must be fun at parties, lol. You’ll have to fabricate anything that would protect the back of the gas tanks on these trucks. It...
-
Ppeats reacted to Keith Seymore's post in the thread 1973 - 1987 Step Side fender splash aprons with Like.
I am sorry to hear that. Keep in mind we built 15 million squarebodies. If 10% were stepside beds then that's still 1.5 million...
-
PIt's funny you mention those plastic stone shields on the fuel tanks. The earlier models did not have those. It turns out, all those...
-
PYou’re the exception to the rule. The same rule that says fuel pumps never fail when the tank is empty, only immediately after filling...
-
PIt probably fell out of the cab corner area like a bunch of other junk when you go to removing the rotten metal...
-
PI figure that’s about as good of a place as any for a 305 crank :gr_grin:
-
Ppeats reacted to Ricko1966's post in the thread Project is stalled. Cannot solve brake problem with Like.
You don't need to match a hydroboost car,you need to match a vacuum car. Or just make a temporary relocation bracket and verify. But I...
-
Ppeats reacted to Ricko1966's post in the thread Project is stalled. Cannot solve brake problem with Like.
Did you adjust the brake booster pushrod properly? Not the rod from the pedal to the master,the one in the booster that pushes on the...
Latest posts
-
-
-
-
-
1987 R10: TH400 to 200-4R swap (mostly wiring??)- Latest: NickTransmissions