peats's latest activity
-
PThe SB K5 Blazers had a habit of rusting differently and much faster than the trucks. I saw Blazers that were 10 years old at the time...
-
PSeems like the market is finally cooling off? I wish it was a higher trim and had the 350 but I have the old 400 out of my k10 I could...
-
Ppeats reacted to Grit dog's post in the thread Searching for My Dad's 1979 Chevy Suburban with
Like.
Do this. Closest youre gonna get to finding what is left of the pile of rust that used to be a daily driver 70s car in the rust belt... -
PI can't say you're a douche,but I can think it. What are you going to whine about today? Actors? Prices?Manufacturers? Websites...
-
PRespectfully disagree, after doing emission work for 20+ years brass floats to not react the same or hold fuel at the same level. I was...
-
PBingo!! Exactly my point, the people who say Q-Jets are junk are either too lazy to study them, too stubborn to learn, or too stupid to...
-
PThis is a pretty good description of what should be happening, but I'll add a few caveats. Early quadrajets like this one only had one...
-
PGet it running again first. Then deal with the carb after you've sorted out the other issues. Reason is you change x y and z at the same...
-
PWhens the last time its gotten plugs wires and a coil? Failing to run on ether is the red flag, its not a carb issue i dont believe
-
PI'm thinking it should at least fire on ether regardless of carb issues. Have you checked for spark at the plugs?
-
PShift levers are manly. Push buttons are not.
-
PAt this stage of the game and not knowing the charge status,what works,etc. I'd unbolt the compressor. Bungee it to one side, pull my...
-
P@Truck82 Gonna sound like your dad here, but if you’re budget constrained and also wanting a 4x4 eventually, you’re doing it all wrong...
-
PYeah, I get that but time for something thicker and with a high zinc content for your cam and lifters. I’ll post a picture below of a...
-
PCut the oil filter open. If it’s clean of metallic debris, put a mechanical gauge on it to verify the oil pressure. If it’s still low...
