peats's latest activity
-
PI run rotella t4 which is 15-40
-
P5-30 is too thin in my opinion for a run of the mill small block or big block. 10-30, 10-40, 15-40, 20-50 for these old mills...
-
PThe sensor on the thermostat housing 1 lead goes to the carb,where you are missing a plug,the other to ground. It provides a path to...
-
PKeep in mind larger tires,wider tires,heavier tires,more aggressive treads all affect mpg. Just don't want posts next, your mpg has...
-
Ppeats replied to the thread 700r4 TV cable cause acceleration/run away with 6.2?.I recently had to replace the throttle cable on my 6.2. It was sticking, not accelerating. Was able to get a GM part.
-
Ppeats replied to the thread Help with starting 79 k20 400SBC.I agree with Nedrow, the timing is way out cause it spits and sputters when it was flipped 180. That means there is spark and fuel present.
-
PPull #1 spark plug out, have someone turn the motor with you plugging the spark plug hole with your thump, on the outside, no finger in...
-
PEverybody,quit using brake cleaner,looking for intake leaks and as starting fluid,mounting tires etc. Burning brake cleaner creates...
-
PYou can have no carbureator on a sbc,as long as it has fuel,spark,and compression it will start,as long as the distributor is half a$$...
-
Ppeats reacted to Ricko1966's post in the thread Can't decide what to do. Suggestions? Thoughts? with
Like.
Rebuild the 350 to 383,small computer friendly cam and long tube's. Lots of torque,that's what pulls trailers.it will be all bolt in and... -
PRPO K05 = block heater We used to use them to heat our water for coffee back in the remote areas of the plant. K
-
Ppeats replied to the thread Engine Block Heater for SBC 350.My 6.2 does not like the cold but it sure likes the factory block heater. I have it on a timer. The quicker you can get the engine up to...
-
PBefore fooling around with block heaters, you need to get the choke sorted out. Zero degrees is not that cold. As mentioned, make sure...
-
PI didn't read all 97 posts. Here's the deal and it's just simple math and physics. If you put a heater in the dip stick or stick one to...
-
PI've started my wore out carbed 350 in -50F and colder. I daily my square in ND all year round. Good battery and cables and proper choke...
